Paragraph 8 Commission Regulation (EC) No 642/2009

(1)

Commission Regulation (EC) No 642/2009 of 22 July 2009 implementing Directive 2005/32/EC of the European Parliament and of the Council with regard to ecodesign requirements for televisions is amended as follows.

(2)

In Article 2 (definitions)—

(a)

at the beginning, for the words from “In addition” to “shall apply:”, substitute—

“The definitions set out in the Ecodesign for Energy-Related Products Regulations 2010 apply; and for any term that is not defined in those Regulations, the definitions set out in Directive 2009/125/EC of the European Parliament and of the Council of 21 October 2009 establishing a framework for the setting of ecodesign requirements for energy-related products, as it had effect immediately before exit day, apply. The following definitions also apply—”;

(b)

for paragraph 7, substitute—

“7.

‘off mode’ means a condition in which the equipment is connected to a mains power source and is not providing any function other than—

(a)
an indication of off mode condition; or

(b)
functionalities intended only to ensure electromagnetic compatibility pursuant to the Electromagnetic Compatibility Regulations 2016;”.

(3)

In Article 4 (conformity assessment), for the first paragraph, substitute—

“For the purposes of regulation 4(2)(a) of the Ecodesign for Energy-Related Products Regulations 2010, the procedure for assessing whether an energy-related product complies with this implementing measure is the internal design control system set out in Part 1 of Schedule 1A to the Ecodesign for Energy-Related Products Regulations 2010 or the management system for assessing conformity set out in Part 2 of Schedule 1A to those Regulations.”.

(4)

Omit Article 6 (revision).

(5)

At the end of Article 8 (entry into force), omit “This Regulation shall be binding in its entirety and directly applicable in all Member States.”.

(6)

Annex 3 (product compliance verification by market surveillance authorities) is amended as follows—

(a)

in each instance, for “Member State” or “Member States”, substitute “United Kingdom”;

(b)

in section A—

(i)

for the first paragraph, substitute—

“When verifying the compliance of a product model with the requirements laid down in this Regulation, for the requirements referred to in this Annex the authorities of the United Kingdom must apply the procedure in subparagraph (1) to (6) below.

The authorities of the United Kingdom must also apply the steps set out in subparagraphs 2(a), 2(b) and 3 below during the verification procedure set out in part B of this Annex.”;

(ii)

in subparagraph (2)(a)—

(aa)

for “point 2 of Annex IV to Directive 2009/125/EC (declared values)” substitute “paragraph 1(2) of Part 1 of Schedule 1A to the Ecodesign for Energy-Related Products Regulations 2010”; and

(bb)

for “paragraph (g) thereof”, substitute “paragraph 1(2)(b)(vii) of Part 1 of Schedule 1A to those Regulations”;

(iii)

subparagraph (7) is omitted;

(iv)

in the third paragraph—

(aa)

for “7” substitute “6”; and

(bb)

for “harmonised” substitute “designated”;

(c)

in section B—

(i)

for the first paragraph, substitute—

“When performing market surveillance checks, the authorities of the United Kingdom must apply the following verification procedure for the requirements set out in subparagraphs 1(d) and 2(c) of section 3 of Annex 1, as applicable. They shall use the applicable procedure below, after having deactivated and/or disconnected, as applicable, all network ports of the unit.”;

(ii)

in the second paragraph, for “Member States’ authorities”, substitute “The United Kingdom authorities”;

(d)

in section C, the words from “, including” to “Union” are omitted.