# The Ecodesign for Energy-Related Products and Energy Information (Amendment) (EU Exit) Regulations 2019, Paragraph 17: Commission Regulation (EU) No 617/2013

Extent: E+W+S+N.I.

(1) Commission Regulation (EU) No 617/2013 of 26 June 2013 implementing Directive 2009/125/EC of the European Parliament and of the Council with regard to ecodesign requirements for computers and computer servers is amended as follows.
(2) In Article 2 (definitions), at the beginning, for “The following definitions shall apply:”, substitute—
“The definitions set out in the Ecodesign for Energy-Related Products Regulations 2010 apply; and for any term that is not defined in those Regulations, the definitions set out in Directive 2009/125/EC of the European Parliament and of the Council of 21 October 2009 establishing a framework for the setting of ecodesign requirements for energy-related products, as it had effect immediately before IP completion day, apply. The following definitions also apply—”.
(3) For Article 6 (conformity assessment), substitute—
“For the purposes of regulation 4(2)(a) of the Ecodesign for Energy-Related Products Regulations 2010, the procedure for assessing whether an energy-related product complies with this implementing measure is the internal design control system set out in Part 1 of Schedule 1A to the Ecodesign for Energy-Related Products Regulations 2010 or the management system for assessing conformity set out in Part 2 of Schedule 1A to those Regulations.”.
(4) In Article 7 (market surveillance and verification procedure), for “Directive 2009/125/EC”, substitute “ the Ecodesign for Energy-Related Products Regulations 2010 ”.
(5) Omit Article 9 (revision).
(6) At the end of Article 10 (entry into force and application), omit “This Regulation shall be binding in its entirety and directly applicable in all Member States.”.
(7) Annex 3 (measurements by market surveillance authorities and product compliance verification by market surveillance authorities) is amended as follows—
(a) in each instance, for “Member State” or “Member States”, substitute “ Great Britain ”;
(b) in section 1 (measurements), in the first paragraph, for the words from “harmonised” to “Union”, substitute “ designated standards ”;
(c) in section 2 (product compliance verification by market surveillance authorities)—
(i) for the first paragraph, substitute—
“When verifying the compliance of a product model with the requirements laid down in this Regulation, for the requirements referred to in this Annex the authorities of Great Britain must apply the following procedure—”;
(ii) in subparagraph (2)(a)—
(aa) for “point 2 of Annex IV to Directive 2009/125/EC (declared values)”, substitute “ paragraph 1(2) of Part 1 of Schedule 1A to the Ecodesign for Energy-Related Products Regulations 2010 ”; and
(bb) for “paragraph (g) thereof”, substitute “ paragraph 1(2)(b)(vii) of Part 1 of Schedule 1A to those Regulations ”;
(iii) omit subparagraph (7); and
(iv) in the third paragraph, for “7” substitute “ 6 ”.
(8) In Annex 4 (indicative benchmarks), for “purpose of Part 3, point 2 of Annex I to Directive 2009/125/EC” substitute “ purposes of this Regulation ”.

---
Source: https://www.legislation.gov.uk/uksi/2019/539/schedule/2/paragraph/17 (the official version)
Page: https://openlegislation.uk/ecodesign-for-energy-related-products-and-energy-information-amendment-eu-exit-regulations-2019/schedule-2/paragraph-17
Contains public sector information licensed under the Open Government Licence v3.0. Source: legislation.gov.uk, The National Archives.