# Commission Decision of 12 May 2011 on the procedure for attesting the conformity of construction products pursuant to Article 20(2) of Council Directive 89/106/EEC as regards power, control and communication cables (notified under document C(2011) 3107) (Text with EEA relevance) (2011/284/EU), Division: Systems of attestation of conformity

Extent: E+W+S+N.I.

For the product(s) and intended use(s) listed below, CEN/Cenelec are requested to specify the following system(s) of attestation of conformity in the relevant harmonised standard(s):
System 3 see point (ii) of Section 2 of Annex III to Directive 89/106/EEC, second possibility.
Product(s)
Intended use(s)
Level(s) or class(es)
Attestation of conformity system(s)
Power, control and communication cables
for uses subject to regulations on dangerous substances
—
3
The specification for the system should be such that it can be implemented even where performance does not need to be determined for a certain characteristic, because at least one Member State has no legal requirement at all for such characteristic (see Article 2(1) of Directive 89/106/EEC and, where applicable, clause 1.2.3 of the Interpretative Documents). In those cases the verification of such a characteristic must not be imposed on the manufacturer if he does not wish to declare the performance of the product in that respect.

---
Source: https://www.legislation.gov.uk/eudn/2011/284/annex/III/division/4/division/1 (the official version)
Page: https://openlegislation.uk/eu-decision-2011-284/annex-III/division-4/division-1
Contains public sector information licensed under the Open Government Licence v3.0. Source: legislation.gov.uk, The National Archives.