Division 5: MEASUREMENTS AND DETERMINATION OF THE POWER SAVINGS - Commission Implementing Decision (EU) 2016/1721 of 26 September 2016 on the approval of the Toyota efficient exterior lighting using light emitting diodes for the use in non-externally chargeable hybrid electrified vehicles as an innovative technology for reducing CO2 emissions from passenger cars pursuant to Regulation (EC) No 443/2009 of the European Parliament and of the Council (Text with EEA relevance)

For each efficient exterior LED light included in the package the measurement of the current shall be performed as shown in the figure at a voltage of 13,2 V. LED module(s) operated by an electronic light source control gear, shall be measured as specified by the applicant.

The manufacturer may request that other measurements of the current shall be done at other additional voltages. In that case, the manufacturer must hand over verified documentation on the necessity to perform these other measurements to the type-approval authority. The measurements of the currents at each of those additional voltages are to be performed consecutively at least five (5) times. The exact installed voltages and the measured current is to be recorded in four decimals.

The power consumption has to be determined by multiplying the installed voltage with the measured current. The average of the power consumption for each efficient exterior LED light ( $\bar{P_{{EI}_{i}}}$ ) has to be calculated. Each value must be expressed in 4 decimals. When a stepper motor or electronic controller is used for the supply of the electricity to the LED lamps, then the electric load of this component part is to be excluded from the measurement.

The resulting power savings of each efficient exterior LED light (ΔP_i) are to be calculated with the following formula:

Division 5 MEASUREMENTS AND DETERMINATION OF THE POWER SAVINGS