# Commission Implementing Decision (EU) 2019/2010 of 12 November 2019 establishing the best available techniques (BAT) conclusions, under Directive 2010/75/EU of the European Parliament and of the Council, for waste incineration (notified under document C(2019) 7987) (Text with EEA relevance), Division: DEFINITIONS Extent: E+W+S+N.I. For the purposes of these BAT conclusions, the following general definitions apply: Directive 2008/98/EC of the European Parliament and of the Council of 19 November 2008 on waste and repealing certain Directives (OJ L 312, 22.11.2008, p. 3). Term Definition General terms Boiler efficiency Ratio between the energy produced at the boiler output (e.g. steam, hot water) and the waste’s and auxiliary fuel’s energy input to the furnace (as lower heating values). Bottom ash treatment plant Plant treating slags and/or bottom ashes from the incineration of waste in order to separate and recover the valuable fraction and to allow the beneficial use of the remaining fraction. This does not include the sole separation of coarse metals at the incineration plant. Clinical waste Infectious or otherwise hazardous waste arising from healthcare institutions (e.g. hospitals). Channelled emissions Emissions of pollutants into the environment through any kind of duct, pipe, stack, chimney, funnel, flue, etc. Continuous measurement Measurement using an automated measuring system permanently installed on site. Diffuse emissions Non-channelled emissions (e.g. of dust, volatile compounds, odour) into the environment, which can result from ‘area’ sources (e.g. tankers) or ‘point’ sources (e.g. pipe flanges). Existing plant A plant that is not a new plant. Fly ashes Particles from the combustion chamber or formed within the flue-gas stream that are transported in the flue-gas. Hazardous waste Hazardous waste as defined in Article 3(2) of Directive 2008/98/EC of the European Parliament and of the Council. Incineration of waste The combustion of waste, either alone or in combination with fuels, in an incineration plant. Incineration plant Either a waste incineration plant as defined in Article 3(40) of Directive 2010/75/EU or a waste co-incineration plant as defined in Article 3(41) of Directive 2010/75/EU, covered by the scope of these BAT conclusions. Major plant upgrade A major change in the design or technology of a plant with major adjustments or replacements of the process and/or abatement technique(s) and associated equipment. Municipal solid waste Solid waste from households (mixed or separately collected) as well as solid waste from other sources that is comparable to household waste in nature and composition. New plant A plant first permitted following the publication of these BAT conclusions or a complete replacement of a plant following the publication of these BAT conclusions. Other non-hazardous waste Non-hazardous waste that is neither municipal solid waste nor sewage sludge. Part of an incineration plant For the purposes of determining the gross electrical efficiency or the gross energy efficiency of an incineration plant, a part of it may refer for example to: an incineration line and its steam system in isolation; a part of the steam system, connected to one or more boilers, routed to a condensing turbine; the rest of the same steam system that is used for a different purpose, e.g. the steam is directly exported. Periodic measurement Measurement at specified time intervals using manual or automated methods. Residues Any liquid or solid waste which is generated by an incineration plant or by a bottom ash treatment plant. Sensitive receptor Area which needs special protection, such as: residential areas; areas where human activities are carried out (e.g. neighbouring workplaces, schools, daycare centres, recreational areas, hospitals or nursing homes). Sewage sludge Residual sludge from the storage, handling and treatment of domestic, urban or industrial waste water. For the purposes of these BAT conclusions, residual sludges constituting hazardous waste are excluded. Slags and/or bottom ashes Solid residues removed from the furnace once wastes have been incinerated. Valid half-hourly average A half-hourly average is considered valid when there is no maintenance or malfunction of the automated measuring system. Regulation (EC) No 850/2004 of the European Parliament and of the Council of 29 April 2004 on persistent organic pollutants and amending Directive 79/117/EEC (OJ L 158, 30.4.2004, p. 7). Term Definition Pollutants and parameters As The sum of arsenic and its compounds, expressed as As. Cd The sum of cadmium and its compounds, expressed as Cd. Cd+Tl The sum of cadmium, thallium and their compounds, expressed as Cd+Tl. CO Carbon monoxide. Cr The sum of chromium and its compounds, expressed as Cr. Cu The sum of copper and its compounds, expressed as Cu. Dioxin-like PCBs PCBs showing a similar toxicity to the 2,3,7,8-substituted PCDD/PCDF according to the World Health Organization (WHO). Dust Total particulate matter (in air). HCl Hydrogen chloride. HF Hydrogen fluoride. Hg The sum of mercury and its compounds, expressed as Hg. Loss on ignition Change in mass as a result of heating a sample under specified conditions. N2O Dinitrogen monoxide (nitrous oxide). NH3 Ammonia. NH4-N Ammonium nitrogen, expressed as N, includes free ammonia (NH3) and ammonium (NH4 +). Ni The sum of nickel and its compounds, expressed as Ni. NOX The sum of nitrogen monoxide (NO) and nitrogen dioxide (NO2), expressed as NO2. Pb The sum of lead and its compounds, expressed as Pb. PBDD/F Polybrominated dibenzo-p-dioxins and –furans. PCBs Polychlorinated biphenyls. PCDD/F Polychlorinated dibenzo-p-dioxins and -furans. POPs Persistent Organic Pollutants as listed in Annex IV to Regulation (EC) No 850/2004 of the European Parliament and of the Council and its amendments. Sb The sum of antimony and its compounds, expressed as Sb. Sb+As+Pb+Cr+Co+Cu+Mn+Ni+V The sum of antimony, arsenic, lead, chromium, cobalt, copper, manganese, nickel, vanadium and their compounds, expressed as Sb+As+Pb+Cr+Co+Cu+Mn+Ni+V. SO2 Sulphur dioxide. Sulphate (SO4 2-) Dissolved sulphate, expressed as SO4 2-. TOC Total organic carbon, expressed as C (in water); includes all organic compounds. TOC content (in solid residues) Total organic carbon content. The quantity of carbon that is converted into carbon dioxide by combustion and which is not liberated as carbon dioxide by acid treatment. TSS Total suspended solids. Mass concentration of all suspended solids (in water), measured via filtration through glass fibre filters and gravimetry. Tl The sum of thallium and its compounds, expressed as Tl. TVOC Total volatile organic carbon, expressed as C (in air). Zn The sum of zinc and its compounds, expressed as Zn. --- Source: https://www.legislation.gov.uk/eudn/2019/2010/annex/division/n2 (the official version) Page: https://openlegislation.uk/eu-decision-2019-2010/annex/division-n2 Contains public sector information licensed under the Open Government Licence v3.0. Source: legislation.gov.uk, The National Archives.