{
  "url": "https://openlegislation.uk/eu-decision-2020-2009/annex/division-1/division-1.1/division-1.1.11/division-1.1.11.1/division-BATn2",
  "json_url": "https://openlegislation.uk/eu-decision-2020-2009/annex/division-1/division-1.1/division-1.1.11/division-1.1.11.1/division-BATn2.json",
  "legislation": "eudn/2020/2009",
  "legislation_title": "Commission Implementing Decision (EU) 2020/2009 of 22 June 2020 establishing the best available techniques (BAT) conclusions, under Directive 2010/75/EU of the European Parliament and of the Council on industrial emissions, for surface treatment using organic solvents including preservation of wood and wood products with chemicals (notified under document C(2020) 4050) (Text with EEA relevance)",
  "legislation_url": "https://openlegislation.uk/eu-decision-2020-2009",
  "path": "annex/division/1/division/1.1/division/1.1.11/division/1.1.11.1/division/BATn2",
  "kind": "division",
  "number": "BAT 15",
  "heading": "In order to reduce VOC emissions in waste gases and increase resource efficiency, BAT is to use one or a combination of the techniques given below.",
  "text": "Technique\nDescription\nApplicability\nI. Capture and recovery of solvents in off-gases\n(a)\nCondensation\nA technique for removing organic compounds by reducing the temperature below their dew points so that the vapours liquefy. Depending on the operating temperature range required, different refrigerants are used, e.g. cooling water, chilled water (temperature typically around 5 °C), ammonia or propane.\nApplicability may be restricted where the energy demand for recovery is excessive due to the low VOC content.\n(b)\nAdsorption using activated carbon or zeolites\nVOCs are adsorbed on the surface of activated carbon, zeolites or carbon fibre paper. Adsorbate is subsequently desorbed, e.g. with steam (often on site), for reuse or disposal and the adsorbent is reused. For continuous operation, typically more than two adsorbers are operated in parallel, one of them in desorption mode. Adsorption is also commonly applied as a concentration step to increase the subsequent oxidation efficiency.\nApplicability may be restricted where the energy demand for recovery is excessive due to the low VOC content.\n(c)\nAbsorption using a suitable liquid\nUse of a suitable liquid to remove pollutants from the off-gas by absorption, in particular soluble compounds and solids (dust). Solvent recovery is possible, for example, using distillation or thermal desorption.\n(For dust removal, see BAT 18.)\nGenerally applicable.\nII. Thermal treatment of solvents in off-gases with energy recovery\n(d)\nSending off-gases to a combustion plant\nPart or all of the off-gases are sent as combustion air and supplementary fuel to a combustion plant (including CHP (combined heat and power) plants) used for steam and/or electricity production.\nNot applicable for off-gases containing substances referred to in IED Article 59(5). Applicability may be restricted due to safety considerations.\n(e)\nRecuperative thermal oxidation\nThermal oxidation using the heat of the waste gases, e.g. to preheat the incoming off-gases.\nGenerally applicable.\n(f)\nRegenerative thermal oxidation with multiple beds or with a valveless rotating air distributor\nAn oxidiser with multiple beds (three or five) filled with ceramic packing. The beds are heat exchangers, alternately heated by flue-waste gases from oxidation, then the flow is reversed to heat the inlet air to the oxidiser. The flow is reversed on a regular basis. In the valveless rotating air distributor, the ceramic medium is held in a single rotating vessel divided into multiple wedges.\nGenerally applicable.\n(g)\nCatalytic oxidation\nOxidation of VOCs assisted by a catalyst to reduce the oxidation temperature and reduce the fuel consumption. Exhaust heat can be recovered with recuperative or regenerative types of heat exchangers. Higher oxidation temperatures (500–750 °C) are used for the treatment of off-gas from the manufacturing of winding wire.\nApplicability may be restricted by the presence of catalyst poisons.\nIII. Treatment of solvents in off-gases without solvent or energy recovery\n(h)\nBiological off-gas treatment\nOff-gas is dedusted and sent to a reactor with biofilter substrate. The biofilter consists of a bed of organic material (such as peat, heather, compost, root, tree bark, softwood and different combinations) or some inert material (such as clay, activated carbon, and polyurethane), where the off-gas stream is biologically oxidised by naturally occurring microorganisms into carbon dioxide, water, inorganic salts and biomass. The biofilter is sensitive to dust, high temperatures or high variations in the off-gas, e.g. of the inlet temperature or the VOC concentration. Supplementary nutrient feeding may be needed.\nOnly applicable to the treatment of biodegradable solvents.\n(i)\nThermal oxidation\nOxidation of VOCs by heating off-gases with air or oxygen to above their auto-ignition point in a combustion chamber and maintaining a high temperature long enough to complete the combustion of VOCs to carbon dioxide and water.\nGenerally applicable.\nBAT-associated emission levels (BAT-AELs) are given in Tables 11, 15, 17, 19, 21, 24, 27, 30, 32 and 35 of these BAT conclusions.",
  "extent": "E+W+S+N.I.",
  "status": null,
  "version": "current",
  "annotations": [],
  "outstanding_effects": [],
  "provenance": {
    "source": "legislation.gov.uk",
    "source_url": "https://www.legislation.gov.uk/eudn/2020/2009/annex/division/1/division/1.1/division/1.1.11/division/1.1.11.1/division/BATn2",
    "retrieved_at": "2026-11-01T15:12:03.527850+00:00"
  },
  "licence": "Open Government Licence v3.0",
  "licence_url": "https://www.nationalarchives.gov.uk/doc/open-government-licence/version/3/",
  "attribution": "Contains public sector information licensed under the Open Government Licence v3.0. Source: legislation.gov.uk, The National Archives."
}