# Commission Implementing Decision (EU) 2020/2009 of 22 June 2020 establishing the best available techniques (BAT) conclusions, under Directive 2010/75/EU of the European Parliament and of the Council on industrial emissions, for surface treatment using organic solvents including preservation of wood and wood products with chemicals (notified under document C(2020) 4050) (Text with EEA relevance), Division BAT 18: In order to reduce dust emissions in waste gases from substrate surface preparation, cutting, coating application and finishing processes for the sectors and processes listed in Table 2, BAT is to use one or a combination of the techniques given below.

Extent: E+W+S+N.I.

Technique
Description
(a)
Wet separation spray booth (flushed impact panel)
A water curtain cascading vertically down the spray cabin rear panel captures paint particles from overspray. The water-paint mixture is captured in a reservoir and the water is recirculated.
(b)
Wet scrubbing
Paint particles and other dust in the off-gas are separated in scrubber systems by intensive mixing of the off-gas with water. (For VOC removal, see BAT 15 (c).)
(c)
Dry overspray separation with pre-coated material
A dry paint overspray separation process using membrane filters combined with limestone as pre-coating material to prevent fouling of the membranes.
(d)
Dry overspray separation using filters
Mechanical separation system, e.g. using cardboard, fabric or sinter.
(e)
Electrostatic precipitator
In electrostatic precipitators, particles are charged and separated under the influence of an electrical field. In a dry electrostatic precipitator (ESP), the collected material is mechanically removed (e.g. by shaking, vibration, compressed air). In a wet ESP, it is flushed with a suitable liquid, usually a water-based separation agent.
Table 2
BAT-associated emission levels (BAT-AELs) for dust emissions in waste gases
Parameter
Sector
Process
Unit
BAT-AEL(Daily average or average over the sampling period)
Dust
Coating of vehicles
Spray coating
mg/Nm3
< 1–3
Coating of other metal and plastic surfaces
Spray coating
Coating of aircraft
Preparation (e.g. sanding, blasting), coating
Coating and printing of metal packaging
Spray application
Coating of wooden surfaces
Preparation, coating
The associated monitoring is given in BAT 11.

---
Source: https://www.legislation.gov.uk/eudn/2020/2009/annex/division/1/division/1.1/division/1.1.11/division/1.1.11.3/division/BAT (the official version)
Page: https://openlegislation.uk/eu-decision-2020-2009/annex/division-1/division-1.1/division-1.1.11/division-1.1.11.3/division-BAT
Contains public sector information licensed under the Open Government Licence v3.0. Source: legislation.gov.uk, The National Archives.

