# Commission Directive 2004/104/EC of 14 October 2004 adapting to technical progress Council Directive 72/245/EEC relating to the radio interference (electromagnetic compatibility) of vehicles and amending Directive 70/156/EEC on the approximation of the laws of the Member States relating to the type-approval of motor vehicles and their trailers (Text with EEA relevance), Article 3

Extent: E+W+S+N.I.

Directive 70/156/EEC is amended as follows:
1.. Annex I is amended as follows:
(a) the following line is added to point 0.5:
‘Name and address of authorised representative, if any:’
(b) the following point is inserted:
‘12.7.
Table of installation and use of RF transmitters in the vehicle(s), if applicable (see Annex I, 3.1.8.):
frequency bands (Hz)
max. output power (W)
antenna position at vehicle, specific conditions for installation and/or use
The applicant for type-approval must also supply, where appropriate:
Appendix 1
A list (with make(s) and type(s) of all electrical and/or electronic components concerned by this Directive (see points 2.1.9 and 2.1.10) and not previously listed.
Appendix 2
Schematics or drawing of the general arrangement of electrical and/or electronic components (concerned by this Directive) and the general wiring harness arrangement.
Appendix 3
Description of vehicle chosen to represent the type
Body style:
Left or right hand drive:
Wheelbase:
Appendix 4
Relevant test report(s) supplied by the manufacturer or approved/recognised laboratories for the purpose of drawing up the type-approval certificate.’
2.. In Annex III, Section A, the following line is added to point 0.5:
‘Name and address of authorised representative, if any:’.

---
Source: https://www.legislation.gov.uk/eudr/2004/104/article/3 (the official version)
Page: https://openlegislation.uk/eu-directive-2004-104/article-3
Contains public sector information licensed under the Open Government Licence v3.0. Source: legislation.gov.uk, The National Archives.