# Directive 2014/68/EU of the European Parliament and of the Council of 15 May 2014 on the harmonisation of the laws of the Member States relating to the making available on the market of pressure equipment (recast) (Text with EEA relevance), Division (b): Resistance

Extent: E+W+S+N.I.

Appropriate design calculations shall be used to establish the resistance of the pressure equipment concerned.
In particular:
the calculation pressures shall not be less than the maximum allowable pressures and take into account static head and dynamic fluid pressures and the decomposition of unstable fluids. Where a vessel is separated into individual pressure-containing chambers, the partition wall shall be designed on the basis of the highest possible chamber pressure relative to the lowest pressure possible in the adjoining chamber,
the calculation temperatures shall allow for appropriate safety margins,
the design shall take appropriate account of all possible combinations of temperature and pressure which might arise under reasonably foreseeable operating conditions for the equipment,
the maximum stresses and peak stress concentrations shall be kept within safe limits,
the calculation for pressure containment shall utilise the values appropriate to the properties of the material, based on documented data, having regard to the provisions set out in point 4 together with appropriate safety factors. Material characteristics to be considered, where applicable, include:
yield strength, 0,2 % or 1,0 % proof strength as appropriate at calculation temperature,
tensile strength,
time-dependent strength, i.e. creep strength,
fatigue data,
Young’s modulus (modulus of elasticity),
appropriate amount of plastic strain,
bending rupture energy,
fracture toughness.
appropriate joint factors shall be applied to the material properties depending, for example, on the type of non-destructive testing, the materials joined and the operating conditions envisaged,
the design shall take appropriate account of all reasonably foreseeable degradation mechanisms (e.g. corrosion, creep, fatigue) commensurate with the intended use of the equipment. Attention shall be drawn, in the instructions referred to in point 3.4, to particular features of the design which are relevant to the life of the equipment, for example:
for creep: design hours of operation at specified temperatures,
for fatigue: design number of cycles at specified stress levels,
for corrosion: design corrosion allowance.

---
Source: https://www.legislation.gov.uk/eudr/2014/68/annex/I/division/1/division/n6/division/2.2/division/2.2.3/division/b (the official version)
Page: https://openlegislation.uk/eu-directive-2014-68/annex-I/division-1/division-n6/division-2.2/division-2.2.3/division-b
Contains public sector information licensed under the Open Government Licence v3.0. Source: legislation.gov.uk, The National Archives.