Division 9.1 Information on basic physical and chemical propertiesX1F1

The following properties shall be clearly identified including, where appropriate, a reference to the test methods used and specification of appropriate units of measurement and/or reference conditions. If relevant for the interpretation of the numerical value, the method of determination shall also be provided (for example, the method for flash point, the open-cup/closed-cup method):

1. (a)

   Appearance:

   The physical state (solid (including appropriate and available safety information on granulometry and specific surface area if not already specified elsewhere in this safety data sheet), liquid, gas) and the colour of the substance or mixture as supplied shall be indicated;

2. (b)

   Odour:

   If odour is perceptible, a brief description of it shall be given;

3. (c)

   Odour threshold;

4. (d)

   pH:

   The pH of the substance or mixture as supplied or of an aqueous solution shall be indicated; in the case of an aqueous solution, the concentration shall also be indicated;

5. (e)

   Melting point/freezing point;

6. (f)

   Initial boiling point and boiling range;

7. (g)

   Flash point;

8. (h)

   Evaporation rate;

9. (i)

   Flammability (solid, gas);

10. (j)

    Upper/lower flammability or explosive limits;

11. (k)

    Vapour pressure;

12. (l)

    Vapour density;

13. (m)

    Relative density;

14. (n)

    Solubility(ies);

15. (o)

    Partition coefficient: n-octanol/water;

16. (p)

    Auto-ignition temperature;

17. (q)

    Decomposition temperature;

18. (r)

    Viscosity;

19. (s)

    Explosive properties;

20. (t)

    Oxidising properties.

If it is stated that a particular property does not apply or if information on a particular property is not available, the reasons shall be given.

To enable proper control measures to be taken, all relevant information on the substance or mixture shall be provided. The information in this section shall be consistent with the information provided in a registration where one is required.

In the case of a mixture, the entries shall clearly indicate to which substance in the mixture the data apply, unless it is valid for the whole mixture.