# Commission Regulation (EC) No 1060/2008 of 7 October 2008 replacing Annexes I, III, IV, VI, VII, XI and XV to Directive 2007/46/EC of the European Parliament and of the Council establishing a framework for the approval of motor vehicles and their trailers, and of systems, components and separate technical units intended for such vehicles (Framework Directive) (Text with EEA relevance), Annex IV

Extent: E+W+S+N.I.

ANNEX VI
MODELS OF THE TYPE-APPROVAL CERTIFICATE
MODEL A
(to be used for type-approval of a vehicle)
Maximum format: A4 (210 × 297 mm)
EC VEHICLE TYPE-APPROVAL CERTIFICATE
Stamp of type-approval authority
Delete where not applicable.
Communication concerning:
Of a type of:
EC type-approval
extension of EC type-approval
refusal of EC type-approval
withdrawal of EC type-approval
complete vehicle
completed vehicle
incomplete vehicle
vehicle with complete and incomplete variants
vehicle with completed and incomplete variants
with regard to Directive 2007/46/EC as last amended by Directive …./…/EC / Regulation (EC) No. …/…
EC type-approval number:
Reason for extension:
SECTION I
0.1.
Make (trade name of manufacturer):
0.2.
Type:
0.2.1.
Commercial name(s):
0.3.
Means of identification of type, if marked on the vehicle:
0.3.1.
Location of that marking:
0.4.
Category of vehicle:
0.5.
Name and address of manufacturer of the complete vehicle:
Name and address of manufacturer of the base vehicle :
Name and address of manufacturer of the latest built stage of the incomplete vehicle :
Name and address of manufacturer of the completed vehicle :
0.8.
Name(s) and address(es) of assembly plant(s):
0.9.
Name and address of the manufacturer's representative (if any):
SECTION II
The undersigned hereby certifies the accuracy of the manufacturer's description in the attached information document of the vehicle(s) described above ((a) sample(s) having been selected by the EC type-approval authority and submitted by the manufacturer as prototype(s) of the vehicle type) and that the attached test results are applicable to the vehicle type.
1.
For complete and completed vehicles/variants:
The vehicle type meets/does not meet the technical requirements of all the relevant regulatory acts as prescribed in Annex IV and Annex XI to Directive 2007/46/EC.
2.
For incomplete vehicles/variants:
The vehicle type meets/does not meet the technical requirements of the regulatory acts listed in the table on side 2.
3.
The approval is granted/refused/withdrawn.
4.
The approval is granted in accordance with Article 20 and the validity of the approval is thus limited to dd/mm/yy.
(Place)
(Signature)
(Date)
Attachments Information package.
Test results (see Annex VIII).
Name(s) and specimen(s) of the signature(s) of the person(s) authorised to sign certificates of conformity and a statement of their position in the company.
NB: If this model is used for type-approval pursuant to Articles 20, 22 or 23, it may not bear the heading “EC Vehicle Type-Approval Certificate”, except:
in the case mentioned in Article 20 where the Commission has decided to allow a Member State to grant a type-approval in accordance with this Directive,
in the case of vehicles of the category M1, type-approved according to the procedure prescribed in Article 22.
EC VEHICLE TYPE-APPROVAL CERTIFICATE
Side 2
This EC type-approval is, where incomplete and completed vehicles, variants or versions are concerned, based on the approval(s) for incomplete vehicles listed below:
Stage 1: Manufacturer of the base vehicle:
EC type-approval number:
Dated:
Applicable to variants or versions (as appropriate):
Stage 2: Manufacturer:
EC type-approval number:
Dated:
Applicable to variants or versions (as appropriate):
Stage 3: Manufacturer:
EC type-approval number:
Dated:
Applicable to variants or versions (as appropriate):
In the case where the approval includes one or more incomplete variants or versions (as appropriate), list those variants or versions (as appropriate) which are complete or completed.
Complete/completed variant(s):
List of requirements applicable to the approved incomplete vehicle type, variant or version (as appropriate, taking account of the scope and latest amendment to each of the regulatory acts listed below).
(List only subjects for which an EC type-approval exists.)
Item
Subject
Regulatory act reference
Last amended
Applicable to variant or, if need be, to version
In the case of special purpose vehicles, exemptions granted or special provisions applied pursuant to Annex XI and exemptions granted pursuant to Article 20:
Regulatory act reference
Item number
Kind of approval and nature of exemption
Applicable to variant or, if need be, to version
Appendix
List of regulatory acts to which the type of vehicle complies
(to be filled in only in the case of type-approval in accordance with Article 6(3))
Or UNECE Regulations that are considered to be equivalent.
Subject
Regulatory act reference
As amended by
Applicable to versions
1.
Permissible sound level
Directive
70/157/EEC
2.
Emissions
Directive
70/220/EEC
2a.
Emissions (Euro 5 and 6) light-duty vehicles/access to information
Regulation
(EC) No 715/2007
3.
Fuel tanks/Rear protective devices
Directive
70/221/EEC
4.
Rear registration plate space
Directive
70/222/EEC
5.
Steering effort
Directive
70/311/EEC
6.
Door latches and hinges
Directive
70/387/EEC
7.
Audible warning
Directive
70/388/EEC
8.
Rear visibility
Directive
71/127/EEC
8a.
Indirect vision devices
Directive
2003/97/EC
9.
Braking
Directive
71/320/EEC
10.
Radio interference (electromagnetic compatibility)
Directive
72/245/EEC
11.
Diesel smoke
Directive
72/306/EEC
12.
Interior fittings
Directive
74/60/EEC
13.
Anti-theft and immobiliser
Directive
74/61/EEC
14.
Protective steering
Directive
74/297/EEC
15.
Seat strength
Directive
74/408/EEC
16.
Exterior projections
Directive
74/483/EEC
17.
Speedometer and reverse gear
Directive
75/443/EEC
18.
Plates (statutory)
Directive
76/114/EEC
19.
Seat-belt anchorages
Directive
76/115/EEC
20.
Installation of lighting and light signalling devices
Directive
76/756/EEC
21.
Retro reflectors
Directive
76/757/EEC
22.
End-outline, front-position (side), rear-position (side), stop, side marker, daytime running lamps
Directive
76/758/EEC
23.
Direction indicators
Directive
76/759/EEC
24.
Rear registration plate lamps
Directive
76/760/EEC
25.
Headlamps (including bulbs)
Directive
76/761/EEC
26.
Front fog lamps
Directive
76/762/EEC
27.
Towing hooks
Directive
77/389/EEC
28.
Rear fog lamps
Directive
77/538/EEC
29.
Reversing lamps
Directive
77/539/EEC
30.
Parking lamps
Directive
77/540/EEC
31.
Seat-belts and restraint systems
Directive
77/541/EEC
32.
Forward vision
Directive
77/649/EEC
33.
Identification of controls, tell-tales and indicators
Directive
78/316/EEC
34.
Defrost/demist
Directive
78/317/EEC
35.
Wash/wipe
Directive
78/318/EEC
36.
Heating systems
Directive
2001/56/EC
37.
Wheel guards
Directive
78/549/EEC
38.
Head restraints
Directive
78/932/EEC
39.
CO2 emissions/Fuel consumption
Directive
80/1268/EEC
40.
Engine power
Directive
80/1269/EEC
41.
Emissions (Euro IV and V) heavy-duty vehicles.
Directive
2005/55/EC
42.
Lateral protection
Directive
89/297/EEC
43.
Spray-suppression systems
Directive
91/226/EEC
44.
Masses and dimensions (cars)
Directive
92/21/EEC
45.
Safety glazing
Directive
92/22/EEC
46.
Tyres
Directive
92/23/EEC
47.
Speed limitation devices
Directive
92/24/EEC
48.
Masses and dimensions (other than vehicles referred to in item 44)
Directive
97/27/EC
49.
External projections of cabs
Directive
92/114/EEC
50.
Couplings
Directive
94/20/EC
51.
Flammability
Directive
95/28/EC
52.
Buses and coaches
Directive
2001/85/EC
53.
Frontal impact
Directive
96/79/EC
54.
Side impact
Directive
96/27/EC
56.
Vehicles intended for the transport of dangerous goods
Directive
98/91/EC
57.
Front under-run protection
Directive
2000/40/EC
58.
Pedestrian protection
Directive
2003/102/EC
59.
Recyclability
Directive
2005/64/EC
60.
Frontal protection systems
Directive
2005/66/EC
61.
Air-conditioning systems
Directive
2006/40/EC
MODEL B
(to be used for type-approval of a system or type-approval of a vehicle with regard to a system)
Maximum format: A4 (210 × 297 mm)
EC TYPE-APPROVAL CERTIFICATE
Stamp of type-approval authority
Communication concerning:
Delete where not applicable.
EC type-approval
of a type of system/type of a vehicle with regard to a system
extension of EC type-approval
refusal of EC type-approval
withdrawal of EC type-approval
with regard to Directive …/…/EC / Regulation (EC) No …/…, as last amended by Directive …/…/EC / Regulation (EC) No …/…
EC type-approval number:
Reason for extension:
SECTION I
0.1.
Make (trade name of manufacturer):
0.2.
Type:
0.2.1.
Commercial name(s) (if available):
0.3.
Means of identification of type, if marked on the vehicle:
0.3.1.
Location of that marking:
0.4.
Category of vehicle:
0.5.
Name and address of manufacturer:
0.8.
Name(s) and address(es) of assembly plant(s):
0.9.
Name and address of the manufacturer's representative (if any):
SECTION II
1.
Additional information (where applicable): see Addendum.
2.
Technical service responsible for carrying out the tests:
3.
Date of test report:
4.
Number of test report:
5.
Remarks (if any): see Addendum.
6.
Place:
7.
Date:
8.
Signature:
Attachments Information package
Test report
Addendum
to EC type-approval certificate No …
1.
Additional information
1.1.
[…]:
1.1.1.
[…]:
[…]
2.
Type-approval number of each component or separate technical unit installed on the vehicle type to comply with this Directive or Regulation
2.1.
[…]:
3.
Remarks
3.1.
[…]:
MODEL C
(to be used for component/separate technical unit type-approval)
Maximum format: A4 (210 × 297 mm)
EC TYPE-APPROVAL CERTIFICATE
Stamp of type-approval authority
Communication concerning:
Delete where not applicable.
EC type-approval
of a type of component/separate technical unit
extension of EC type-approval
refusal of EC type-approval
withdrawal of EC type-approval
with regard to Directive …/…/EC / Regulation (EC) No …/…, as last amended by Directive …/…/EC / Regulation (EC) No …/…
EC type-approval number:
Reason for extension:
SECTION I
0.1.
Make (trade name of manufacturer):
0.2.
Type:
0.3.
Means of identification of type, if marked on the component/separate technical unit :
0.3.1.
Location of that marking:
0.5.
Name and address of manufacturer:
0.7.
In the case of components and separate technical units, location and method of affixing of the EC approval mark:
0.8.
Name(s) and address(es) of assembly plant(s):
0.9.
Name and address of the manufacturer's representative (if any):
SECTION II
1.
Additional information (where applicable): see Addendum
2.
Technical service responsible for carrying out the tests:
3.
Date of test report:
4.
Number of test report:
5.
Remarks (if any): see Addendum
6.
Place:
7.
Date:
8.
Signature:
Attachments Information package.
Test report.
Addendum
to EC type-approval certificate No …
1.
Additional information
1.1.
[…]:
1.1.1.
[…]:
[…]
2.
Restriction of use of the device (if any)
2.1.
[…]:
3.
Remarks
3.1.
[…]:

---
Source: https://www.legislation.gov.uk/eur/2008/1060/annex/IV (the official version)
Page: https://openlegislation.uk/eu-regulation-2008-1060/annex-IV
Contains public sector information licensed under the Open Government Licence v3.0. Source: legislation.gov.uk, The National Archives.