# Commission Regulation (EC) No 692/2008 of 18 July 2008 implementing and amending Regulation (EC) No 715/2007 of the European Parliament and of the Council on type-approval of motor vehicles with respect to emissions from light passenger and commercial vehicles (Euro 5 and Euro 6) and on access to vehicle repair and maintenance information (Text with EEA relevance), Appendix Addendum to EC type-approval certificate No …: concerning the type-approval of a vehicle with regard to emissions and access to vehicle repair and maintenance information according to Regulation (EC) No 715/2007

Extent: E+W+S+N.I.

1.
Additional information
1.1.
Mass of the vehicle in running order:
1.2.
Maximum mass:
1.3.
Reference mass:
1.4.
Number of seats:
1.6.
Type of bodywork:
1.6.1.
for M1, M2: saloon, hatchback, station wagon, coupé, convertible, multipurpose vehicle
1.6.2.
for N1, N2: lorry, van
1.7.
Drive wheels: front, rear, 4 x 4
1.8.
Pure electric vehicle: yes/no
1.9.
Hybrid electric vehicle: yes/no
1.9.1.
Category of Hybrid Electric vehicle: Off Vehicle Charging/Not Off Vehicle charging
1.9.2.
Operating mode switch: with/without
1.10.
Engine identification:
1.10.1.
Engine displacement:
1.10.2.
Fuel supply system: direct injection/indirect injection
1.10.3.
Fuel recommended by the manufacturer:
1.10.4.
Maximum power: kW at min'
1.10.5.
Pressure charging device: yes/no
1.10.6.
Ignition system: compression ignition/positive ignition
1.11.
Power train (for pure electric vehicle or hybrid electric vehicle)
1.11.1.
Maximum net power: … kW, at: … to … min-1
1.11.2.
Maximum thirty minutes power: … kW
1.11.3
Maximum net torque: … Nm, at … min –1
1.12.
Traction battery (for pure electric vehicle or hybrid electric vehicle)
1.12.1.
Nominal voltage: V
1.12.2.
Capacity (2 h rate): Ah
1.13.
Transmission: …,
1.13.1.
Type of gearbox: manual/automatic/variable transmission
1.13.2.
Number of gear ratios:
1.13.3.
Total gear ratios (including the rolling circumferences of the tyres under load): road speeds per 1 000 min-1 (km/h)
First gear:
Sixth gear:
Second gear:
Seventh gear:
Third gear:
Eighth gear:
Fourth gear:
Overdrive:
Fifth gear:
1.13.4.
Final drive ratio:
1.14.
Tyres: …,, …
Type: … Dimensions:
Rolling circumference under load:
Rolling circumference of tyres used for the Type 1 test
2.
Test results
2.1.
Tailpipe emissions test results
Emissions classification: Euro 5/Euro 6
Type 1 test results, where applicable
Type approval number if not parent vehicle:
Where applicable.
Not applicable.
Mean value calculated by adding mean values (M.Ki) calculated for THC and NOx.
Round to 2 decimal places.
Round to 4 decimal places.
Round to 1 decimal place more than limit value.
Type 1 Result
Test
CO(mg/km)
THC(mg/km)
NMHC(mg/km)
NOx(mg/km)
THC + NOx(mg/km)
Particulates(mg/km)
Particles(#/km)
Measured
1
2
3
Measured mean value (M)
Ki
Mean value calculated with Ki (M.Ki)
DF
Final mean value calculated with Ki and DF (M.Ki.DF)
Limit value
Information about regeneration strategy
D — number of operating cycles between 2 cycles where regenerative phases occur:
d — number of operating cycles required for regeneration:
Type 2: %
Type 3:
Type 4: g/test
Delete where not applicable (there are cases where nothing needs to be deleted when more than one entry is applicable.)
Type 5:
Durability test: whole vehicle test/bench ageing test/none
Deterioration factor DF: calculated/assigned
Specify the values:
Type 6
CO (g/km)
THC (g/km)
Measured value
2.1.1.
For bi fuel vehicles, the type 1 table shall be repeated for both fuels. For flex fuel vehicles, when the type 1 test is to be performed on both fuels according to Figure I.2.4 of Annex I to Regulation (EC) No 692/2008, and for vehicles running on LPG or NG/Biomethane, either mono fuel or bi fuel, the table shall be repeated for the different reference gases used in the test, and an additional table shall display the worst results obtained. When applicable, in accordance with sections 1.1.2.4 and 1.1.2.5 of Annex I to Regulation (EC) No 692/2008, it shall be shown if the results are measured or calculated.
2.1.2.
Written description and/or drawing of the MI:
2.1.3.
List and function of all components monitored by the OBD system:
2.1.4.
Written description (general working principles) for:
2.1.4.1.
Misfire detection:
2.1.4.2.
Catalyst monitoring:
2.1.4.3.
Oxygen sensor monitoring:
2.1.4.4.
Other components monitored by the OBD system:
2.1.4.5.
Catalyst monitoring:
2.1.4.6.
Particulate trap monitoring:
2.1.4.7.
Electronic fuelling system actuator monitoring:
2.1.4.8.
Other components monitored by the OBD system:
2.1.5.
Criteria for MI activation (fixed number of driving cycles or statistical method):
2.1.6.
List of all OBD output codes and formats used (with explanation of each):
2.2.
Emissions data required for roadworthiness testing
Delete where not applicable (there are cases where nothing needs to be deleted when more than one entry is applicable.)
Test
CO value(% vol)
Lambda
Engine speed(min-)
Engine oil temperature(°C)
Low idle test
N/A
High idle test
2.3.
Catalytic converters yes/no
2.3.1.
Original equipment catalytic converter tested to all relevant requirements of this Regulation yes/no
2.4.
Smoke opacity test results
2.4.1.
At steady speeds: See technical service test report number:
2.4.2.
Free acceleration tests
2.4.2.1.
Measured value of the absorption coefficient: … m-1
2.4.2.2.
Corrected value of the absorption coefficient: … m-1
2.4.2.3.
Location of the absorption coefficient symbol on the vehicle:
2.5.
CO2 emissions and fuel consumption test results
2.5.1.
Internal combustion engine vehicle and Not Externally Chargeable (NOVC) Hybrid Electric Vehicle
2.5.1.1.
CO2 mass emissions (provide declared values for each reference fuel tested)
2.5.1.1.1.
CO2 mass emissions (urban conditions): … g/km
2.5.1.1.2.
CO2 mass emissions (extra-urban conditions): … g/km
2.5.1.1.3.
CO2 mass emissions (combined): … g/km
2.5.1.2.
Fuel consumption (provide declared values for each reference fuel tested)
2.5.1.2.1.
Fuel consumption (urban conditions): … 1/100 km
2.5.1.2.2.
Fuel consumption (extra-urban conditions): … 1/100 km
2.5.1.2.3.
Fuel consumption (combined): … 1/100 km
2.5.1.3.
For vehicles powered by an internal combustion engine only which are equipped with periodically regenerating systems as defined in paragraph 6 of Article 2 of this Regulation, the test results shall be multiplied by the factor Ki as specified in Annex 10 to UN/ECE Regulation 101.
2.5.1.3.1.
Information about regeneration strategy for CO2 emissions and fuel consumption
D — number of operating cycles between 2 cycles where regenerative phases occur:
d — number of operating cycles required for regeneration:
Round to 4 decimal places.
urban
extra urban
combined
Ki
Values for CO2
and fuel consumption
2.5.2.
Pure electric vehicles
2.5.2.1.
Electric energy consumption (declared value).
2.5.2.1.1.
Electric energy consumption: Wh/km
2.5.2.1.2.
Total time out of tolerance for the conduct of the cycle: … sec
2.5.2.2.
Range (declared value): km
2.5.3.
Externally chargeable (OVC) Hybrid Electric Vehicle:
2.5.3.1.
CO2 mass emission (Condition A, combined): g/km
2.5.3.2.
CO2 mass emission (Condition B, combined): g/km
2.5.3.3.
CO2 mass emission (weighted, combined): g/km
2.5.3.4.
Fuel consumption (Condition A, combined): … l/100 km
2.5.3.5.
Fuel consumption (Condition B, combined): … l/100 km
2.5.3.6.
Fuel consumption (weighted, combined): … l/100 km
2.5.3.7.
Electric energy consumption (Condition A, combined): Wh/km
2.5.3.8.
Electric energy consumption (Condition B, combined): Wh/km
2.5.3.9.
Electric energy consumption (weighted and combined): Wh/km
2.5.3.10.
Pure electric range: km
2.6.
Test results of eco-innovations
Number of the Commission Decision approving the eco-innovation.
Assigned in the Commission Decision approving the eco-innovation.
If modelling is applied instead of the type 1 test-cycle, this value shall be the one provided by the modelling methodology.
Sum of the emissions saving of each individual eco-innovation.
Decision approving the eco-innovation
Code of the eco-innovation
1. CO 2 emissions of the baseline vehicle (g/km)
2. CO 2 emissions of the eco-innovation vehicle (g/km)
3. CO 2 emissions of the baseline vehicle under type 1 test-cycle
4. CO 2 emissions of the eco-innovation vehicle under type 1 test-cycle (= 3.5.1.3)
5. Usage factor (UF)i.e. temporal share of technology usage in normal operation conditions
CO 2 emissions savings 1 − 2 − 3 − 4 × 5
xxxx/201x
Total CO 2 emissions saving (g/km)
2.6.1.
General code of the eco-innovation(s) : …
3.
Vehicle repair information
3.1.
Address of website for access to vehicle repair and maintenance information: …
3.1.1.
Date from which it is available (up to 6 months from the date of type approval):
3.2.
Terms and conditions of access (i.e. duration of access, price of access on a hourly, daily, monthly, annual and per-transaction basis) to websites referred to in point 3.1):
3.3.
Format of vehicle repair and maintenance information accessible through website referred to in Section 3.1:
3.4.
Manufacturer’s certificate on access to vehicle repair and maintenance information provided: …
4.
Power measurement
Maximum engine net power of internal combustion engine, net power and maximum 30 minutes power of electric drive train
4.1.
Internal combustion engine net power
4.1.1.
Engine speed (rpm)
4.1.2.
Measured fuel flow (g/h)
4.1.3.
Measured torque (Nm)
4.1.4.
Measured power (kW)
4.1.5.
Barometric pressure (kPa)
4.1.6.
Water vapour pressure (kPa)
4.1.7.
Intake air temperature (K)
4.1.8.
Power correction factor when applied
4.1.9.
Corrected power (kW)
4.1.10.
Auxiliary power (kW)
4.1.11.
Net power (kW)
4.1.12.
Net torque (Nm)
4.1.13.
Corrected specific fuel consumption (g/kWh)
4.2.
Electric drive train(s):
4.2.1.
Declared figures
4.2.2.
Maximum net power: … kW, at … min –1
4.2.3.
Maximum net torque: … Nm, at … min –1
4.2.4.
Maximum net torque at zero speed: .… Nm
4.2.5.
Maximum 30 minutes power: … kW
4.2.6.
Essential characteristics of the electric drive train
4.2.7.
Test DC voltage: … V
4.2.8.
Working principle:
4.2.9.
Cooling system:
4.2.10.
Motor: liquid/air
4.2.11.
Variator: liquid/air
5.
Remarks:

---
Source: https://www.legislation.gov.uk/eur/2008/692/annex/I/appendix/Addendum (the official version)
Page: https://openlegislation.uk/eu-regulation-2008-692/annex-I/appendix-Addendum
Contains public sector information licensed under the Open Government Licence v3.0. Source: legislation.gov.uk, The National Archives.