{
  "url": "https://openlegislation.uk/eu-regulation-2009-761/annex-I/division-1/division-1.5/division-1.5.7/division-1.5.7.3",
  "json_url": "https://openlegislation.uk/eu-regulation-2009-761/annex-I/division-1/division-1.5/division-1.5.7/division-1.5.7.3.json",
  "legislation": "eur/2009/761",
  "legislation_title": "Commission Regulation (EC) No 761/2009 of 23 July 2009 amending, for the purpose of its adaptation to technical progress, Regulation (EC) No 440/2008 laying down test methods pursuant to Regulation (EC) No 1907/2006 of the European Parliament and of the Council on the Registration, Evaluation, Authorisation and Restriction of Chemicals (REACH) (Text with EEA relevance)",
  "legislation_url": "https://openlegislation.uk/eu-regulation-2009-761",
  "path": "annex/I/division/1/division/1.5/division/1.5.7/division/1.5.7.3",
  "kind": "division",
  "number": "1.5.7.3",
  "heading": "Procedure",
  "text": "The flow rate of the effluent carrier gas is measured at room temperature. The flow rate is checked frequently during the experiment to assure that there is an accurate value for the total volume of carrier gas. Continuous monitoring with a mass flow-meter is preferred. Saturation of the gas phase may require considerable contact time and hence quite low gas flow rates (25).\nAt the end of the experiment, both the front and backup sorbent sections are analysed separately. The compound on each section is desorbed by adding a solvent. The resulting solutions are analysed quantitatively to determine the weight desorbed from each section. The choice of the analytical method (also the choice of sorbent and desorbing solvent) is dictated by the nature of the test material. The desorption efficiency is determined by injecting a known amount of sample onto the sorbent, desorbing it and analysing the amount recovered. It is important to check the desorption efficiency at or near the concentration of the sample under the test conditions.\nTo assure that the carrier gas is saturated with the test substance, three different gas flow rates are used. If the calculated vapour pressure shows no dependence on flow rate, the gas is assumed to be saturated.\nThe vapour pressure is calculated through the equation:\np = W V × RT M\nwhere:\np vapour pressure (Pa)\nW mass of evaporated test substance (g)\nV volume of saturated gas (m3)\nR universal gas constant 8,314 (J mol–1 K–1)\nT temperature (K)\nM molar mass of test substance (g mol–1)\nMeasured volumes must be corrected for pressure and temperature differences between the flow meter and the saturator.",
  "extent": "E+W+S+N.I.",
  "status": null,
  "version": "current",
  "annotations": [],
  "outstanding_effects": [],
  "provenance": {
    "source": "legislation.gov.uk",
    "source_url": "https://www.legislation.gov.uk/eur/2009/761/annex/I/division/1/division/1.5/division/1.5.7/division/1.5.7.3",
    "retrieved_at": "2026-11-01T14:51:19.625001+00:00"
  },
  "licence": "Open Government Licence v3.0",
  "licence_url": "https://www.nationalarchives.gov.uk/doc/open-government-licence/version/3/",
  "attribution": "Contains public sector information licensed under the Open Government Licence v3.0. Source: legislation.gov.uk, The National Archives."
}