# Commission Regulation (EU) No 406/2010 of 26 April 2010 implementing Regulation (EC) No 79/2009 of the European Parliament and of the Council on type-approval of hydrogen-powered motor vehicles (Text with EEA relevance), Division 3.1.1.2


The secondary pressure relief device for the inner tank shall be installed to ensure that the pressure in the tank cannot under any circumstances exceed the permissible fault range of the inner tank. In the case of steel inner tanks, the secondary pressure relief device shall limit the pressure in the tank to 136 per cent of the Maximum Allowable Working Pressure (MAWP) of the inner tank, if a safety valve is used as secondary pressure relief device. In case of steel inner tanks, the secondary pressure relief device shall limit the pressure in the tank to 150 per cent of the Maximum Allowable Working Pressure (MAWP) of the inner tank, if a burst disk is used outside the vacuum area as secondary pressure relief device. In case of steel inner tanks, the secondary pressure relief device shall limit the pressure in the tank to 150 per cent of the Maximum Allowable Working Pressure plus 0,1 MPa (MAWP + 0,1 MPa) of the inner tank, if a burst disk is used inside the vacuum area as secondary pressure relief device. For other materials, an equivalent level of safety shall be demonstrated. The secondary pressure relief device shall not operate below 110 per cent of the set pressure of the primary pressure relief device.

---
Source: https://www.legislation.gov.uk/eur/2010/406/annex/III/part/3/division/3/division/3.1/division/3.1.1/division/3.1.1.2 (the official version)
Page: https://openlegislation.uk/eu-regulation-2010-406/annex-III/part-3/division-3/division-3.1/division-3.1.1/division-3.1.1.2
Contains public sector information licensed under the Open Government Licence v3.0. Source: legislation.gov.uk, The National Archives.

