# Commission Regulation (EU) No 582/2011 of 25 May 2011 implementing and amending Regulation (EC) No 595/2009 of the European Parliament and of the Council with respect to emissions from heavy duty vehicles (Euro VI) and amending Annexes I and III to Directive 2007/46/EC of the European Parliament and of the Council (Text with EEA relevance), Appendix Addendum: to GB type-approval certificate No …

Extent: E+W+S+N.I.

1.
ADDITIONAL INFORMATION
1.1.
Particulars to be completed in relation to the type-approval of a vehicle with an engine installed:
1.1.1.Make of engine (name of undertaking):
1.1.2.Type and commercial description (mention any variants):
1.1.3.Manufacturer's code as marked on the engine:
1.1.4.Category of vehicle (if applicable) (b):
1.1.5.Category of engine: Diesel/Petrol/LPG/NG-H/NG-L/NG-HL/Ethanol (ED95)/Ethanol (E85)/LNG/LNG 20 ( 1 ):
1.1.5.1.Type of dual-fuel engine: Type 1A/Type 1B/Type 2A/Type 2B/Type 3B ( 1 )( d1 ):
1.1.6.Name and address of manufacturer:
1.1.7.Name and address of manufacturer's authorised representative (if any):
1.2.
If the engine referred to in 1.1 has been type approved as a separate technical unit:
1.2.1.Type-approval number of the engine/engine family (1):
1.2.2.Engine Control Unit (ECU) software calibration number:
1.3.
Particulars to be completed in relation to the type-approval of an engine/engine family (1) as a separate technical unit (conditions to be respected in the installation of the engine on a vehicle):
1.3.1.Maximum and/or minimum intake depression:
1.3.2.Maximum allowable back pressure:
1.3.3.Exhaust system volume:
1.3.4.Restrictions of use (if any):
1.4.
Emission levels of the engine/parent engine ( 1 )
Deterioration Factor (DF): calculated/fixed ( 1 )
Specify the DF values and the emissions on the WHSC (if applicable) and WHTC tests in the table below
1.4.1.
WHSC test
Table 4
WHSC test
WHSC test (if applicable) ( 10 )( d5 )
DF
CO
THC
NMHC ( d4 )
NO X
PM Mass
NH 3
PM Number
Mult/add ( 1 )
Emissions
CO (mg/kWh)
THC (mg/kWh)
NMHC ( d4 ) (mg/kWh)
NO x (mg/kWh)
PM Mass (mg/kWh)
NH 3 ppm
PM Number (#/kWh)
Test result
Calculated with DF
CO 2 mass emission: … g/kWh
Fuel consumption … g/kWh
1.4.2.
WHTC test
Table 5
WHTC Test
WHTC test ( 10 )( d5 )
DF
CO
THC
NMHC ( d4 )
CH4 ( d4 )
NO x
PM Mass
NH 3
PM Number
Mult/add ( 1 )
Emissions
CO (mg/kWh)
THC (mg/kWh)
NMHC ( d4 ) (mg/kWh)
CH4 ( d4 ) (mg/kWh)
NO x (mg/kWh)
PM Mass (mg/kWh)
NH 3 ppm
PM Number (#/kWh)
Cold start
Hot start w/o regeneration
Hot start with regeneration ( 1 )
k r,u (mult/add) ( 1 )
k r,d (mult/add) ( 1 )
Weighted test result
Final test result with DF
CO 2 mass emission: … g/kWh
Fuel consumption: … g/kWh
1.4.3.
Idle test
Table 6
Idle test
Test
CO value(% vol.)
Lambda (1)
Engine speed (min–1)
Engine oil temperature (°C)
Low idle test
N/A
High idle test
1.4.4.
PEMS demonstration test
Table 6a
PEMS demonstration test
Vehicle type (e.g. M 3 , N 3 and application e.g. rigid or articulated truck, city bus)
Vehicle description (e.g. vehicle model, prototype)
Pass-fail results ( 7 )
CO
THC
NMHC
CH 4
NO x
PM mass
Work window conformity factor
CO 2 mass window conformity factor
Trip information
Urban
Rural
Motorway
Shares of time of the trip characterised by urban, rural and motorway operation as described in point 4.5 of Annex II to Regulation (EU) No 582/2011
Shares of time of the trip characterised by accelerating, decelerating, cruising and stop as described in point 4.5.5 of Annex II to Regulation (EU) No 582/2011
Minimum
Maximum
Work window average power (%)
CO 2 mass window duration (s)
Work window: percentage of valid windows
CO 2 mass window: percentage of valid windows
Fuel consumption consistency ratio
1.5
Power measurement
1.5.1.
Engine power measured on test bench
Table 7
Engine power measured on test bench
Measured engine speed (rpm)
Measured fuel flow (g/h)
Measured torque (Nm)
Measured power (kW)
Barometric pressure (kPa)
Water vapour pressure (kPa)
Intake air temperature (K)
Power correction factor
Corrected power (kW)
Auxiliary power (kW) (1)
Net power (kW)
Net torque (Nm)
Corrected specific fuel consumption (g/kWh)
1.5.2.
Additional data, e.g. the power correction factor for each fuel declared (if applicable)

---
Source: https://www.legislation.gov.uk/eur/2011/582/annex/I/appendix/Addendum+1 (the official version)
Page: https://openlegislation.uk/eu-regulation-2011-582/annex-I/appendix-Addendum+1
Contains public sector information licensed under the Open Government Licence v3.0. Source: legislation.gov.uk, The National Archives.