Division 21.A.3A Reporting systemF1

System for Collection, Investigation and Analysis of Data

The holder of a type-certificate, restricted type-certificate, supplemental type-certificate, F2United Kingdom Technical Standard Order (F3UKTSO) authorisation, major repair design approval or any other relevant approval deemed to have been issued under this Regulation shall have a system for collecting, investigating and analysing reports of and information related to failures, malfunctions, defects or other occurrences which cause or might cause adverse effects on the continuing airworthiness of the product, part or appliance covered by the type-certificate, restricted type-certificate, supplemental type-certificate, UKTSO authorisation, major repair design approval or any other relevant approval deemed to have been issued under this Regulation. Information about this system shall be made available to all known operators of the product, part or appliance and, on request, to any person authorised under other associated implementing Regulations.

Reporting to the F4CAA

1. 1..

   The holder of a type-certificate, restricted type-certificate, supplemental type-certificate, F5UKTSO authorisation, major repair design approval or any other relevant approval deemed to have been issued under this Regulation shall report to the F6CAA any failure, malfunction, defect or other occurrence of which it is aware related to a product, part, or appliance covered by the type-certificate, restricted type-certificate, supplemental type-certificate, F7UKTSO authorisation, major repair design approval or any other relevant approval deemed to have been issued under this Regulation, and which has resulted in or may result in an unsafe condition.

2. 2..

   These reports shall be made in a form and manner established by the F8CAA, as soon as practicable and in any case dispatched not later than 72 hours after the identification of the possible unsafe condition, unless exceptional circumstances prevent this.

Investigation of Reported Occurrences

1. 1..

   When an occurrence reported under point (b), or under points 21.A.129(f)(2) or 21.A.165(f)(2) results from a deficiency in the design, or a manufacturing deficiency, the holder of the type-certificate, restricted type-certificate, supplemental type-certificate, major repair design approval, F9UKTSO authorisation, or any other relevant approval deemed to have been issued under this Regulation, or the manufacturer as appropriate, shall investigate the reason for the deficiency and report to the F10CAA the results of its investigation and any action it is taking or proposes to take to correct that deficiency.

2. 2..

   If the F11CAA finds that an action is required to correct the deficiency, the holder of the type-certificate, restricted type-certificate, supplemental type-certificate, major repair design approval, F12UKTSO authorisation, or any other relevant approval deemed to have been issued under this Regulation, or the manufacturer as appropriate, shall submit the relevant data to the F13CAA.