# Commission Regulation (EU) No 617/2013 of 26 June 2013 implementing Directive 2009/125/EC of the European Parliament and of the Council with regard to ecodesign requirements for computers and computer servers (Text with EEA relevance), Division 3: E TEC , SLEEP MODE, OFF MODE AND LOWEST POWER STATE:

Extent: E+W+S+N.I.

(1)For power demand requirements larger than 1,00 W, or where energy consumption requirements formulated in TEC result in a power demand requirement larger than 1,00 W in at least one power mode, the model configuration shall be considered to comply with the applicable requirements set out in points 1.1, 1.2, 1.3, 1.4, 2.2 and 2.3 of Annex II if the test results do not exceed the respective verification tolerances given in the table below.
Verification tolerances for power demand requirements larger than 1,00 W
Requirements set out
Verification tolerances
Points 1.1, 1.2, 1.3, 1.4 and 2.3 of Annex II
The determined value shall not exceed the declared value by more than 7 %.
Point 2.2 of Annex II (with and without the additional allowance listed in point 2.4)
The determined value shall not exceed the declared value by more than 7 %.
The additional allowances provided for in point 2.4 of Annex II can be added to the requirement specified in point 2.2 if the model configuration is placed on the market with a WOL functionality enabled in sleep mode. The model configuration should be tested with WOL functionality both enabled and disabled and should comply with both requirements. The model configuration placed on the market without ethernet capability shall be tested without WOL enabled.
(2)For power demand requirements less than or equal to 1,00 W, the model configuration shall be considered to comply with the applicable requirements set out in point 3.1 and 4.1 of Annex II if the test results do not exceed the respective verification tolerances given in the table below.
Verification tolerances for power demand requirements of 1,00 W and smaller
Requirements set out
Verification tolerances
Point 3.1 of Annex II (with and without the additional allowance specified in point 3.3)
The determined value shall not exceed the declared value by more than 0,10 W.
Point 4.1 of Annex II (with and without the additional allowances listed in point 4.3)
The determined value shall not exceed the declared value by more than 0,10 W.
The additional allowance provided for in point 3.3 of Annex II can be added to the requirement specified in point 3.1 if the model configuration is placed on the market with an ‘information or status display’.
The additional allowance provided for in point 4.3 of Annex II can be added to the requirement set out in point 4.1 if the model configuration is placed on the market with a WOL functionality enabled in off mode. The model configuration should be tested with WOL functionality both enabled and disabled and should comply with both requirements. The model configuration placed on the market without ethernet capability shall be tested without WOL enabled.

---
Source: https://www.legislation.gov.uk/eur/2013/617/annex/III/division/3 (the official version)
Page: https://openlegislation.uk/eu-regulation-2013-617/annex-III/division-3
Contains public sector information licensed under the Open Government Licence v3.0. Source: legislation.gov.uk, The National Archives.