# Commission Implementing Regulation (EU) 2015/504 of 11 March 2015 implementing Regulation (EU) No 167/2013 of the European Parliament and of the Council with regard to the administrative requirements for the approval and market surveillance of agricultural and forestry vehicles (Text with EEA relevance), Division 2.1.1

Extent: E+W+S+N.I.

The information on the plate shall be clearly legible, indelible and shall contain the following information in the order given below and in accordance with one of the two alternative models set out in Appendix 1:
2.1.1.1. Name of the manufacturer, and trade name (only if different than the name of the manufacturer);
2.1.1.2. Vehicle category including the subcategory and the speed index (1);
2.1.1.3. EU type-approval number in accordance with point 3 of Annex VI;
2.1.1.4. Vehicle identification number (VIN); consisting of a structured combination of characters in accordance with the requirements set out in section 3 of this Annex;
2.1.1.5. Technically permissible maximum laden mass of the vehicle, in the following format: ‘kg’;
2.1.1.6. Technically permissible maximum mass per axle; this information must be listed in order from front to rear, in the following format: ‘A-1: … kg’‘A-2: … kg’‘A-…: … kg’;
2.1.1.7. For C-category vehicles, in addition, technically permissible maximum mass per set of track trains, and, in the same line, average contact pressure on the ground; this information must be combined with that provided for point 2.1.1.6 and listed in order from front to rear, in the following format: ‘S-1: … kg P: … kPa’‘S-2: … kg P: … kPa’‘S-…: … kg P: … kPa’. Each entry separated by one or more spaces;
2.1.1.8. Technically permissible towable mass(es) for each chassis/ braking configuration of the towed R- or S-category vehicle in accordance with entry 4.1.3 of the information document data entries laid down in Part B of Annex I to this Regulation ( 2 ), in the following format: ‘B-1’ unbraked, ‘B-2’ inertia braked, ‘B-3’ hydraulic braked, ‘B-4’ pneumatic braked, ‘T-1’ drawbar, ‘T-2’ rigid drawbar, ‘T-3’ centre-axle;
2.1.1.9. For rigid drawbar or centre-axle R- and S-category vehicles, the vertical load on the coupling point (S). The coupling point shall be deemed the first axle and be numbered ‘0’, in the following format: ‘A-0: … kg’;
2.1.1.10. For vehicles fitted with transition engines, as defined in Article 3(32) of Regulation (EU) 2016/1628, the vehicle's production date in the following format: ‘ MM/YYYY ’ . Alternatively, the vehicle's production date shall be stated in an additional separate statutory plate stating also the VIN.

---
Source: https://www.legislation.gov.uk/eur/2015/504/annex/IV/division/2/division/2.1.1 (the official version)
Page: https://openlegislation.uk/eu-regulation-2015-504/annex-IV/division-2/division-2.1.1
Contains public sector information licensed under the Open Government Licence v3.0. Source: legislation.gov.uk, The National Archives.