# Commission Regulation (EU) 2017/1151 of 1 June 2017 supplementing Regulation (EC) No 715/2007 of the European Parliament and of the Council on type-approval of motor vehicles with respect to emissions from light passenger and commercial vehicles (Euro 5 and Euro 6) and on access to vehicle repair and maintenance information, amending Directive 2007/46/EC of the European Parliament and of the Council, Commission Regulation (EC) No 692/2008 and Commission Regulation (EU) No 1230/2012 and repealing Commission Regulation (EC) No 692/2008 (Text with EEA relevance), Division 4.2.1.1.2: Using an interpolation method


At the request of the manufacturer, an interpolation method may be applied.
In this case, two test vehicles shall be selected from the family complying with the respective family requirement.
Test vehicle H shall be the vehicle producing the higher, and preferably highest, cycle energy demand of that selection, test vehicle L the one producing the lower, and preferably lowest, cycle energy demand of that selection.
All items of optional equipment and/or body shapes that are chosen not to be considered when applying the interpolation method shall be identical for both test vehicles H and L such that these items of optional equipment produce the highest combination of the cycle energy demand due to their road load relevant characteristics (i.e. mass, aerodynamic drag and tyre rolling resistance).
In the case where individual vehicles may be supplied with a complete set of standard wheels and tyres and a complete set of snow tyres (marked with 3 Peaked Mountain and Snowflake – 3PMS) with or without wheels, the additional wheels/tyres shall not be considered as optional equipment.
As a guidance, the following minimum deltas between vehicles H and L should be fulfilled for that road load relevant characteristic:
(i)mass at least 30 kg;
(ii)rolling resistance at least 1,0 kg/t;
(iii)aerodynamic drag CD × A at least 0,05 m2.
To achieve a sufficient delta between vehicle H and L on a particular road load relevant characteristic, the manufacturer may artificially worsen vehicle H, e.g. by applying a higher test mass.

---
Source: https://www.legislation.gov.uk/eur/2017/1151/annex/Sub/4/division/division/4./division/4.2./division/4.2.1./division/4.2.1.1./division/4.2.1.1.2. (the official version)
Page: https://openlegislation.uk/eu-regulation-2017-1151/annex-Sub/4/division/division-4./division-4.2./division-4.2.1./division-4.2.1.1./division-4.2.1.1.2.
Contains public sector information licensed under the Open Government Licence v3.0. Source: legislation.gov.uk, The National Archives.

