OpenLegislation

Division 5.2.5.1.1 Calculation of MTSF1

United Kingdom

Original text. Later amendments are not shown.

In order to calculate the MTS the transient mapping procedure shall be performed in accordance with point 7.4. The MTS is then determined from the mapped values of engine speed versus power. MTS shall be calculated by means of one of the following options:

  1. (a)

    Calculation based upon low speed and high speed values

    MTS = n lo + 0,95 · ( n hi – n lo ) (6-1)

    where:

    n hi
  2. is the high speed as defined in Article 1(12),

  3. n lo
  4. is the low speed as defined in Article 1(13).

  • (b)

    Calculation based upon the longest vector method

    MTS = n i (6-2)

    where:

    n i
  • is the average of the lowest and highest speeds at which ( n 2 norm i  +  P 2 norm i ) is equal to 98 % of the maximum value of ( n 2 norm i  +  P 2 norm i )

  • If there is only one speed at which the value of ( n 2 norm i  +  P 2 norm i ) is equal to 98 % of the maximum value of ( n 2 norm i  +  P 2 norm i ):

    MTS = n i (6-3)

    where:

    n i
  • is the speed at which the maximum value of ( n 2 norm i  +  P 2 norm i ) occurs.

  • where:

    n
  • is the engine speed

  • i
  • is an indexing variable that represents one recorded value of an engine map

  • n norm i
  • is an engine speed normalized by dividing it by n P max

  • P norm i
  • is an engine power normalized by dividing it by P max

  • n P max
  • is the average of the lowest and highest speeds at which power is equal to 98 % of P max .

  • Linear interpolation shall be used between the mapped values to determine:

    1. (i)

      the speeds where power is equal to 98 % of P max . If there is only one speed at which power is equal to 98 % of P max , n P max shall be the speed at which P max occurs;

    2. (ii)

      the speeds where ( n 2 norm i  +  P 2 norm i ) is equal to 98 % of the maximum value of ( n 2 norm i  +  P 2 norm i ).

    Annotations

    Textual amendments

    F1

    Substituted by Commission Delegated Regulation (EU) 2018/989 of 18 May 2018 amending and correcting Delegated Regulation (EU) 2017/654 supplementing Regulation (EU) 2016/1628 of the European Parliament and of the Council with regard to technical and general requirements relating to emission limits and type-approval for internal combustion engines for non-road mobile machinery (Text with EEA relevance).