# Commission Delegated Regulation (EU) 2019/2199 of 17 October 2019 amending Council Regulation (EC) No 428/2009 setting up a Community regime for the control of exports, transfer, brokering and transit of dual-use items, Division 7B: Test, Inspection and Production Equipment

Extent: E+W+S+N.I.

7B001 Test, calibration or alignment equipment, specially designed for equipment specified in 7A.
Note: 7B001 does not control test, calibration or alignment equipment for ‘Maintenance Level I’ or ‘Maintenance Level II’.
7B001 Technical Notes:
1.
‘ Maintenance Level I ’
The failure of an inertial navigation unit is detected on the "aircraft" by indications from the Control and Display Unit (CDU) or by the status message from the corresponding sub-system. By following the manufacturer's manual, the cause of the failure may be localised at the level of the malfunctioning Line Replaceable Unit (LRU). The operator then removes the LRU and replaces it with a spare.
2.
‘ Maintenance Level II ’
The defective LRU is sent to the maintenance workshop (the manufacturer's or that of the operator responsible for level II maintenance). At the maintenance workshop, the malfunctioning LRU is tested by various appropriate means to verify and localise the defective Shop Replaceable Assembly (SRA) module responsible for the failure. This SRA is removed and replaced by an operative spare. The defective SRA (or possibly the complete LRU) is then shipped to the manufacturer. ‘Maintenance Level II’ does not include the disassembly or repair of controlled accelerometers or gyro sensors.
7B002 Equipment specially designed to characterize mirrors for ring "laser" gyros, as follows:
N.B. SEE ALSO 7B102.
a.. Scatterometers having a measurement "accuracy" of 10 ppm or less (better);
b.. Profilometers having a measurement "accuracy" of 0,5 nm (5 angstrom) or less (better).
7B003 Equipment specially designed for the "production" of equipment specified in 7A.
Note: 7B003 includes:
Gyro tuning test stations;
Gyro dynamic balance stations;
Gyro run-in/motor test stations;
Gyro evacuation and fill stations;
Centrifuge fixtures for gyro bearings;
Accelerometer axis align stations;
Fibre optic gyro coil winding machines.
7B102 Reflectometers specially designed to characterise mirrors, for "laser" gyros, having a measurement accuracy of 50 ppm or less (better).
7B103 "Production facilities" and "production equipment" as follows:
a.. "Production facilities" specially designed for equipment specified in 7A117;
b.. "Production equipment", and other test, calibration and alignment equipment, other than that specified in 7B001 to 7B003, designed or modified to be used with equipment specified in 7A.

---
Source: https://www.legislation.gov.uk/eur/2019/2199/annex/I/division/9/division/7B (the official version)
Page: https://openlegislation.uk/eu-regulation-2019-2199/annex-I/division-9/division-7B
Contains public sector information licensed under the Open Government Licence v3.0. Source: legislation.gov.uk, The National Archives.