Division 4 This Annex does not apply to type-approvals granted in accordance with the UN Regulations listed in Annex II to Regulation (EU) 2018/858.

However, this Annex applies to F1GB type-approvals of components and separate technical units granted in accordance with Regulation (EC) No 661/2009 on the basis of requirements laid down in the UN Regulations listed in Annex II to that Regulation, in which case the following shall apply:

1. (a)

   the distinguishing type-approval marking shall be as prescribed in the applicable UN Regulation;

2. (b)

   where the applicable UN Regulation requires a circle surrounding the letter ‘E’ to be part of the type-approval mark, a rectangle rather than a circle shall be used. The height of the rectangle shall correspond to at least the prescribed diameter of the circle and its width shall exceed that value. F2Instead of the upper-case letter ‘E’, the lower-case letter ‘g’ shall be used, followed by the number 11.

Example of a type-approval mark for a type-approval granted F3..., on the basis of requirements laid down in the UN Regulation 28 (¹²⁷) of the Economic Commission for Europe of the United Nations (UN/ECE), on uniform provisions concerning the approval of audible warning devices and of motor vehicles with regard to their audible signals, listed in Annex II to Regulation (EU) 2018/858, original series, first approval issued, for a Class II audible warning device incorporating new technologies: