Paragraph 7 PROCEDURE
Test sample
Take a quantity of fertiliser weighing between 2 and 10 g depending on the declared content of the element in the product. The following table shall be used to obtain a final solution which, after appropriate dilution, will be within the measuring range for each method. The samples should be weighed to within 1 mg.
| Declared content of trace element in the fertiliser (%) | < 0.01 | 0.01-< 5 | ≥ 5-10 |
|---|---|---|---|
| Mass of test sample (g) | 10 | 5 | 2 |
| Mass of element in the sample (mg) | 1 | 0.5-250 | 100-200 |
| Volume of extract V (ml) | 250 | 500 | 500 |
| Concentration of element in extract (mg/l) | 4 | 1-500 | 200-400 |
-
Place the sample in a 250 or 500 ml flask (according to the Table).
Preparation of the solution
Add about 200 ml of water to the 250 ml flask or 400 ml of water to the 500 ml flask.
Stopper the flask well. Shake vigorously by hand to disperse the sample, then place the flask on the shaker and shake for 30 minutes.
Make up to volume with water and mix thoroughly.
Preparation of the test solution
Filter immediately into a clean, dry flask. Stopper the flask. Carry out the determination immediately after filtering.
Note:
If the filtrate gradually becomes cloudy, make another extraction following 7.1 and 7.2 in a flask of volume Ve. Filter into a calibrated flask of volume W which has previously been dried and has received 5.00 ml of dilute hydrochloric acid (4.1). Stop the filtration at the exact moment when the calibration mark is reached. Mix thoroughly.
-
Under these conditions the value of V in the expression of results is:
-
The dilution in the expression of results depend on this value of V.