# The Fireworks (Safety) Regulations 1997, 


Substitute the following for Appendix A—
“A.1 Test paper
A.1.1 Requirements
When determined in accordance with BS EN ISO 536, after conditioning as specified in BS EN 20187, the grammage of the paper shall be 70g/m2±5g/m2.
A.1.2 Conditioning prior to use
The test paper shall be conditioned at (20±4) °C and (65±5)% relative humidity for at least 24 h immediately prior to use.
A.2 Flame witness paper
The test paper shall comply with A.1.1 and shall also be subjected to the scorch test described in A.3 immediately prior to use. The highest sheet in the stack which shows no sign of discoloration after being subjected to the scorch test described shall be sheet ‘6’, ‘7’, ‘8’, ‘9’ or ‘10’.
A.3 Scorch test
A.3.1 Material
A.3.1.1 Cigarette(s), untipped, of length 70mm±4mm, diameter 8.0mm±0.5mm and mass 1.0g±0.1g, and having a smouldering rate of 12.0 min±3.0 min over 50mm distance when determined in accordance with appendix D.
A.3.2 Apparatus
A.3.2.1 Metal plate, mass 225g±1g, dimensions as shown in figure A.1, with a rectangular hole cut in the centre (as shown). The mass of the plate shall be reduced to 225g by drilling holes symmetrically around the plate as necessary.
NOTE. The four holes in figure A.1 are shown as an example only.
A.3.3 Test specimen
Take twelve sheets of the paper, each at least 205mm×105mm, number them consecutively (for identification) and assemble them in a stack, with the matt surfaces (if any) uppermost and sheet ‘1’ on the top.
A.3.4 Procedure
A.3.4.1 Place the test specimen (A.3.3) on a flat, smooth, wooden surface and place the metal plate (A.3.2.1) on top of the stack (i.e. on top of sheet ‘1’) so that the paper projects out around the edges. Light a cigarette (A.3.1.1) and allow it to burn at least 10mm along its length.
A.3.4.2 Place the burning cigarette on the exposed paper in a position which is at least 10mm from any edge of the rectangular hole in the metal plate, and so that it will burn inwards, and then remove the cigarette after 60 s.
Figure A.1. Metal plate for scorch test. All dimensions are in mm
A.3.4.3 Repeat the operations described in A.3.4.2 a further four times, each time selecting a different position which is at least 10mm from any edge and at least 10mm from any scorch mark. If the cigarette has burnt more than 40mm along its length, light a new cigarette, allow it to burn 10mm and then use it for the next position.
A.3.4.4 Examine each sheet of paper and determine which is the highest sheet (i.e. that with the lowest number) which shows no sign of discoloration.”

---
Source: https://www.legislation.gov.uk/uksi/1997/2294/schedule/1/crossheading/1 (the official version)
Page: https://openlegislation.uk/fireworks-safety-regulations-1997/schedule-1/crossheading-1
Contains public sector information licensed under the Open Government Licence v3.0. Source: legislation.gov.uk, The National Archives.