# The Pipe-lines (Metrication) Regulations 1992, Regulation 2: Amendment of Pipe-lines Act 1962


(1) In this regulation any reference to a section or a Schedule followed by a number is a reference to the section or Schedule bearing that number in the Pipe-lines Act 1962.
(2) With effect from 1st January 1995—
(a) in the following provisions (which specify the minimum scale of a map on which the route of a pipe-line is delineated)—
(i) sections 2(2)(b) and 8(1)(b);
(ii) paragraphs 1(b) and 7 of Schedule 1; and
(iii) paragraphs 1(b) and 7(1) of Schedule 2, “six inches to the mile” there shall be substituted “1 in 10,560”;
(b) in the following provisions (which specify the maximum length of a pipe-line for certain purposes)—
(i) section 3(1);
(ii) section 7(1); and
(iii) the definition of “cross-country pipe-line” in section 66(1), “ten miles”, in each place where they occur, there shall be substituted “16.093 kilometres”; and
(c) in section 27(1) and (6) (which specify the minimum distance between a pipe-line and a building or structure) and 31(1) (which specifies the minimum distance between a pipe-line and any deposit of earth or other materials) for the words “ten feet” there shall be substituted “3 metres”.

---
Source: https://www.legislation.gov.uk/uksi/1992/449/regulation/2 (the official version)
Page: https://openlegislation.uk/pipe-lines-metrication-regulations-1992/regulation-2
Contains public sector information licensed under the Open Government Licence v3.0. Source: legislation.gov.uk, The National Archives.