# The Supply of Machinery (Safety) Regulations 2008, Regulation 11: Annex IV machinery manufactured fully in accordance with designated standards and fully covered by such standards

Extent: E+W+S

(1) This regulation applies to machinery—
(a) which falls within a category which is referred to in Annex IV (Part 4 of Schedule 2); and
(b) in respect of which both of the following conditions are satisfied—
(i) that the machinery is manufactured in accordance with designated standards; and
(ii) that the designated standards in accordance with which it is manufactured cover all the applicable essential health and safety requirements.
(2) Where this regulation applies, the responsible person shall follow one of the following conformity assessment procedures—
(a) the conformity assessment procedure with internal checks on the manufacture of machinery prescribed in Annex VIII (Part 8 of Schedule 2); or
(b) the Type- examination procedure prescribed in Annex IX (Part 9 of Schedule 2) and the internal checks on the manufacture of machinery prescribed in Annex VIII, point 3; or
(c) the full quality assurance procedure prescribed in Annex X (Part 10 of Schedule 2).

---
Source: https://www.legislation.gov.uk/uksi/2008/1597/regulation/11 (the official version)
Page: https://openlegislation.uk/supply-of-machinery-safety-regulations-2008/regulation-11
Contains public sector information licensed under the Open Government Licence v3.0. Source: legislation.gov.uk, The National Archives.