# The Supply of Machinery (Safety) Regulations 2008, Regulation 12: Annex IV machinery not manufactured fully in accordance with designated standards or not fully covered by such standards

Extent: E+W+S

(1) This regulation applies to machinery—
(a) which falls within a category which is referred to in Annex IV (Part 4 of Schedule 2); and
(b) in respect of which any of the following conditions is satisfied—
(i) that the machinery is not manufactured in accordance with the designated standards which relate to it; or
(ii) that the machinery is only partly manufactured in accordance with the designated standards which relate to it; or
(iii) that the designated standards in accordance with which the machinery is manufactured do not cover all the applicable essential health and safety requirements; or
(iv) that no designated standards exist for the machinery.
(2) Where this regulation applies, the responsible person shall follow one of the following conformity assessment procedures—
(a) the Type- examination procedure prescribed in Annex IX (Part 9 of Schedule 2) and the internal checks on the manufacture of machinery prescribed in Annex VIII (Part 8 of Schedule 2), point 3; or
(b) the full quality assurance procedure prescribed in Annex X (Part 10 of Schedule 2).

---
Source: https://www.legislation.gov.uk/uksi/2008/1597/regulation/12 (the official version)
Page: https://openlegislation.uk/supply-of-machinery-safety-regulations-2008/regulation-12
Contains public sector information licensed under the Open Government Licence v3.0. Source: legislation.gov.uk, The National Archives.