# The Supply of Machinery (Safety) Regulations 2008, Paragraph


The CE conformity marking shall consist of the initials “CE” taking the following form:
If the CE marking is reduced or enlarged the proportions shown in the above drawing must be respected.
The various components of the CE marking must have substantially the same vertical dimension, which may not be less than 5 mm. The minimum dimension may be waived for small-scale machinery.
The CE marking must be affixed in the immediate vicinity of the name of the responsible person, using the same technique.
Where the full quality assurance procedure prescribed in Annex X (Part 10 of this Schedule) has been applied, the CE marking must be followed by the identification number of the notified body.
The UK marking must be affixed in the immediate vicinity of the name of the responsible person, using the same technique.
Where the full quality assurance procedure prescribed in Annex X (Part 10 of this Schedule) has been applied, the UK marking must be followed by the identification number of the approved body.

---
Source: https://www.legislation.gov.uk/uksi/2008/1597/schedule/2/part/3/paragraph/wrapper3n1 (the official version)
Page: https://openlegislation.uk/supply-of-machinery-safety-regulations-2008/schedule-2/part-3/paragraph-wrapper3n1
Contains public sector information licensed under the Open Government Licence v3.0. Source: legislation.gov.uk, The National Archives.