OpenLegislation

Paragraph 6

Changes not yet applied. Later legislation changes this provision in ways not yet written into the text below:

In regulation 13 of the Measuring Equipment (Capacity Measures and Testing Equipment) Regulations 1995f1, for paragraph (3) there shall be substituted the following paragraph:—

“(3)

A body is an “approved body” for the purposes of this regulation if it is a body in a member State or in an EEA State which has responsibility in that State for metrological control of capacity measures or is a laboratory which has been accredited for the purposes of testing capacity measures in a member State or in an EEA State as being a body which conforms with the criteria set out in BS EN ISO/IEC 17025:2000f2.”.

Annotations

Footnotes

f1

S.I. 1995/735, to which there are amendments which are not relevant to these Regulations.

f2

BS EN ISO/IEC 17025:2000 is the international standard “General requirements for the competence of testing and calibration laboratories” (IBSN 0 580 34929 2).