Regulation 6 Conformity assessmentI1
England, Wales and Scotland
A manufacturer assessing the compliance of a household tumble dryer with the ecodesign requirements must use either—
the internal design control procedure set out in Part 1 of Schedule 1A to the 2010 Regulations, or
the management system procedure set out in Part 2 of that Schedule.
The technical documentation required for the conformity assessment of a household tumble dryer must contain—
the declared values of parameters listed in paragraphs 2, 4 and 6 of Schedule 2, if applicable, and
the details and results of the calculations made in accordance with Schedule 4.
Where the information included in the technical documentationf1 for a particular model of household tumble dryer has been obtained by either of the means specified in paragraph (4), the technical documentation must include—
the details of the calculation,
the assessment undertaken by the manufacturer to verify the accuracy of the calculation, and
where appropriate, the declaration of identity between the models of different manufacturers.
The means are—
from a model that has the same technical characteristics relevant for the technical information to be provided but is produced by a different manufacturer, or
by calculation on the basis of design or extrapolation from another model of the same or a different manufacturer, or both.
The technical documentation must include a list of all equivalent models, including the model identifiers.
The technical documentation must include the information set out in Schedule 5 in the same order as in that Schedule.
Annotations
Commencement
- I1
Reg. 6 in force at 10.4.2026, see reg. 2(1)(a)
Footnotes
- f1
-
See paragraph 1 (2) of Schedule 1A to the 2010 Regulations for the meaning of “technical documentation”. Schedule 1A was inserted by S.I. 2019/539.