OpenLegislation

The Electricity Safety, Quality and Continuity (Amendment) Regulations 2009

S.I. 2009/639 · Made 9 March 2009

Original text. legislation.gov.uk does not revise statutory instruments, so later amendments are not shown here. Changes made to it are listed under each provision when known.

Electricity

Made 9th March 2009

Laid before Parliament 13th March 2009

Coming into force 6th April 2009

The Secretary of State makes the following Regulations in exercise of his powers under section 29 of the Electricity Act 1989f1.

Annotations to the whole text

Footnotes

f1

1989 c.29; section 29 of the Electricity Act 1989 was amended by section 94 of the Energy Act 2004 (c.20).

Contents

  1. 1Citation and commencement
  2. 2Amendment to the Electricity Safety, Quality and Continuity Regulations 2002
  3. Signature
  4. Explanatory note

1Citation and commencement

These Regulations may be cited as the Electricity Safety, Quality and Continuity (Amendment) Regulations 2009 and shall come into force on 6th April 2009.

2Amendment to the Electricity Safety, Quality and Continuity Regulations 2002

(1)

Regulation 1(5) of the Electricity Safety, Quality and Continuity Regulations 2002f1 is amended as follows.

(2)

In the definition of “British Standard Requirements” for the words from “2001 IEE Wiring Regulations” to the end substitute “2008 IEE Wiring Regulations 17th Edition (ISBN 978-0-86341-844-0)”.

Signature

Mike O’Brien

Minister of State,

Department of Energy and Climate Change

9th March 2009

Explanatory note

(This note is not part of the Regulations)

These Regulations amend the Electricity Safety, Quality and Continuity Regulations 2002 (S.I. 2002/2665) (“the ESQCR”).

Regulation 2 incorporates the latest revision to the British Standard Requirements for electrical installations (BS 7671) into the ESQCR. The revision enhances the requirements for protection for persons and livestock against injury, and property against damage caused by voltage disturbances and electromagnetic influences.

The British Standard Requirements are a joint publication by the British Standards Institution and The Institution of Engineering and Technology. Copies can be obtained from The Institution of Engineering and Technology, Michael Faraday House, Six Hills Way, Stevenage, Herts, SG1 2AY.

An Impact Assessment is available and can be obtained from the Department of Energy and Climate Change’s website at: www.decc.gov.uk.. Copies of the Impact Assessment have been placed in the libraries of both Houses of Parliament.

These Regulations were notified in draft to the European Commission and the Member States in accordance with Directive 98/34/EC of the European Parliament and of the Council (O.J. No. L204, 21.7.98, p.37), as amended by Directive 98/48/EC of the European Parliament and of the Council (O.J. No. L217, 5.8.98, p.18).