Division Systems of attestation of conformity

United Kingdom

For the product(s) and intended use(s) listed below, CEN/Cenelec are requested to specify the following system(s) of attestation of conformity in the relevant harmonised standard(s):

Applies to small diameter power or signal cables or systems (< 20 mm diameter and with conductor sizes ≤ 2,5 mm²).
System 1 + see point (i) of Section 2 of Annex III to Directive 89/106/EEC, with audit-testing of samples taken at the factory.
Product(s)	Intended use(s)	Level(s) or class(es)(resistance to fire)	Attestation of conformity system(s)
Power, control and communication cables	for uses subject to fire regulations on resistance to fire	P15 – P30 – P60 – P90 – P120 PH15^f1 – PH 30 – PH 60 – PH 90 – PH 120	1 +

Applies to small diameter power or signal cables or systems (< 20 mm diameter and with conductor sizes ≤ 2,5 mm²).

System 1 +

see point (i) of Section 2 of Annex III to Directive 89/106/EEC, with audit-testing of samples taken at the factory.

Product(s)

Intended use(s)

Level(s) or class(es)(resistance to fire)

Attestation of conformity system(s)

Power, control and communication cables

for uses subject to fire regulations on resistance to fire

P15 – P30 – P60 – P90 – P120

PH15^f1 – PH 30 – PH 60 – PH 90 – PH 120

1 +

The specification for the system should be such that it can be implemented even where performance does not need to be determined for a certain characteristic, because at least one Member State has no legal requirement at all for such characteristic (see Article 2(1) of Directive 89/106/EEC and, where applicable, clause 1.2.3 of the Interpretative Documents). In those cases the verification of such a characteristic must not be imposed on the manufacturer if he does not wish to declare the performance of the product in that respect.

Annotations

Footnotes

f1: Applies to small diameter power or signal cables or systems (< 20 mm diameter and with conductor sizes ≤ 2,5 mm²).