OpenLegislation

Commission Implementing Decision of 7 October 2014 amending Decision 2007/131/EC on allowing the use of the radio spectrum for equipment using ultra-wideband technology in a harmonised manner in the Community (notified under document C(2014) 7083) (2014/702/EU) (revoked)

EU Decision 2014/702 · Adopted 7 October 2014 · Extends to United Kingdom

Original text. legislation.gov.uk does not revise this item, so later amendments are not shown here. Changes made to it are listed under each provision when known.

Commission Implementing Decision

of 7 October 2014

amending Decision 2007/131/EC on allowing the use of the radio spectrum for equipment using ultra-wideband technology in a harmonised manner in the Community

(notified under document C(2014) 7083)

(2014/702/EU) (revoked)

F1. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Annotations to the whole text

Textual amendments

F1

Decision revoked (31.12.2020) by The Radio Spectrum (EU Exit) Regulations 2018 (S.I. 2018/1385), reg. 1, Sch. 2 para. 34; 2020 c. 1, Sch. 5 para. 1(1)

Contents

  1. 1Article 1 Repealed
  2. 2Article 2 Repealed
  3. 3Article 3 Repealed
  4. Signature
  5. Annex Repealed
  6. 1GENERIC UWB USAGE Repealed
  7. 2LOCATION TRACKING SYSTEMS TYPE 1 (LT1) Repealed
  8. 3UWB DEVICES INSTALLED IN ROAD AND RAIL VEHICLES Repealed
  9. 4UWB ONBOARD AIRCRAFT Repealed
  10. MATERIAL SENSING DEVICES USING UWB TECHNOLOGY Repealed
  11. 5.1Material sensing devices Repealed
  12. Building material analysis devices (BMA) Repealed
  13. 1BMA Devices permitted under this Decision shall fulfil the following requirements: Repealed
  14. 2Emissions radiating from BMA devices shall be kept to a minimum and in any case not exceed the maximum power limits within the table below with the BMA device on a representative wall as defined within ETSI Standards EN 302 435-1 and EN 302 498-2. Repealed

1F1

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

2F1

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

3F1

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Signature

F1. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

1GENERIC UWB USAGEF1

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

2LOCATION TRACKING SYSTEMS TYPE 1 (LT1)F1

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

3UWB DEVICES INSTALLED IN ROAD AND RAIL VEHICLESF1

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

4UWB ONBOARD AIRCRAFTF1

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

5.1Material sensing devicesF1

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

1BMA Devices permitted under this Decision shall fulfil the following requirements:F1

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

2Emissions radiating from BMA devices shall be kept to a minimum and in any case not exceed the maximum power limits within the table below with the BMA device on a representative wall as defined within ETSI Standards EN 302 435-1 and EN 302 498-2.F1

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .