Annex II

EN 300 698 V2.3.1

Radio telephone transmitters and receivers for the maritime mobile service operating in the VHF bands used on inland waterways; Harmonised Standard for access to radio spectrum and for features for emergency services

Notice: Compliance with this harmonised standard does not confer a presumption of conformity to the essential requirement set out in Article 3(2) of Directive 2014/53/EU if, in clause 8.2.3 of this harmonised standard, the sentence ‘With the output power switch set at maximum, the carrier power shall be within ±1,5 dB of the rated output power under normal test condition s’ is applied.

EN 302 065-3 V2.1.1

Short Range Devices (SRD) using Ultra Wide Band technology (UWB); Harmonised Standard covering the essential requirements of Article 3.2 of the Directive 2014/53/EU; Part 3: Requirements for UWB devices for ground based vehicular applications

Notice: This harmonised standard does not set out technical specifications for ‘trigger-before-transmit techniques’. Implementing Decision (EU) 2019/785, however, imposes, as of 16 November 2019, technical requirements to be used within the bands 3,8-4,2 GHz and 6-8,5 GHz for vehicular access systems using trigger-before-transmit. Therefore compliance with this harmonised standard does not ensure compliance with Implementing Decision (EU) 2019/785 and accordingly does not confer a presumption of conformity with those essential requirements set out in Article 3(2) of Directive 2014/53/EU which relate to ‘trigger-before-transmit techniques’.

EN 303 520 V1.2.1

Short Range Devices (SRD); Ultra Low Power (ULP) wireless medical capsule endoscopy devices operating in the band 430 MHz to 440 MHz; Harmonised Standard for access to radio spectrum

Notice: Compliance with this harmonised standard does not confer a presumption of conformity with the essential requirement set out in Article 3(2) of Directive 2014/53/EU if any of the following are applied:

• with respect to clause B.1 of Annex B: ‘The manufacturer and test laboratory may agree on alternative suitable implementation of human torso simulator, which shall be then fully described in the test report’;

• with respect to clause C.1 of Annex C: ‘Alternatively, the manufacturer and test laboratory may agree to use a Semi-Anechoic Room, the setup of which shall be then fully described in the test report’.

Notice: The temperature referred to in clause B.2 of Annex B shall reflect the intended use.

EN 301 908-13 V13.1.1

IMT cellular networks; Harmonised Standard for access to radio spectrum; Part 13: Evolved Universal Terrestrial Radio Access (E-UTRA) User Equipment (UE)

Notice : This harmonised standard does not contain antenna performance parameters and compliance with this harmonised standard does not confer a presumption of conformity with the essential requirement set out in Article 3(2) of Directive 2014/53/EU as regards those parameters.

EN 302 217-2 V3.2.2

Fixed Radio Systems; Characteristics and requirements for point-to-point equipment and antennas; Part 2: Digital systems operating in frequency bands from 1 GHz to 86 GHz; Harmonised Standard for access to radio spectrum

Notice : Compliance with this harmonised standard does not confer a presumption of conformity with the essential requirement set out in Article 3(2) of Directive 2014/53/EU if note 2 of clause 4.3.2 of this harmonised standard is applied;

Notice : As regards the radio equipment covered by either clause H.3.4, I.3.4 or J.3.4 of this harmonised standard, compliance with this harmonised standard does not confer a presumption of conformity with the essential requirement set out in Article 3(2) of Directive 2014/53/EU in case that the appropriate test methods are not carried out in order to demonstrate compliance, respectively, with either clause H.3.4, I.3.4 or J.3.4 of this harmonised standard.

EN 303 213-6-1 V3.1.1

Advanced Surface Movement Guidance and Control System (A-SMGCS); Part 6: Harmonised Standard for access to radio spectrum for deployed surface movement radar sensors; Sub-part 1: X-band sensors using pulsed signals and transmitting power up to 100 kW

Notice : As regards clause 4.2.1.5 of this harmonised standard, compliance of this harmonised standard does not confer a presumption of conformity with the essential requirement set out in Article 3(2) of Directive 2014/53/EU to equipment not combining a ‘ WR112/R84 taper section and a WR90/R100 Waveguide ’ as in note 1 of Section 1 of this harmonised standard. The waveguide is requested to have a continuously unobstructed transmission path (unperturbed/pure) and a minimum length of 20 times the waveguide cut-off wavelength in that operational mode.

EN 303 345-2 V1.1.1

Broadcast Sound Receivers; Part 2: AM broadcast sound service; Harmonised Standard for access to radio spectrum

Notice : Compliance with this harmonised standard does not confer a presumption of conformity with the essential requirement set out in Article 3(2) of Directive 2014/53/EU as regards the receiver unwanted emissions in the spurious domain.

EN 303 345-5 V1.1.1

Broadcast Sound Receivers; Part 5: DRM broadcast sound service; Harmonised Standard for access to radio spectrum

Notice : Compliance with this harmonised standard does not confer a presumption of conformity with the essential requirement set out in Article 3(2) of Directive 2014/53/EU as regards the receiver unwanted emissions in the spurious domain.

EN 303 364-3 V1.1.1

Primary Surveillance Radar (PSR); Harmonised Standard for access to radio spectrum; Part 3: Air Traffic Control (ATC) PSR sensors operating in the frequency band 8 500 MHz to 10 000 MHz (X band)

Notice : As regards clause 4.2.1.4 of this harmonised standard, compliance with this harmonised standard does not confer a presumption of conformity with the essential requirement set out in Article 3(2) of Directive 2014/53/EU to equipment not combining a ‘ WR112/R84 taper section and a WR90/R100 Waveguide ’ as in note 1 of Section 1 of this harmonised standard. The waveguide is requested to have a continuously unobstructed transmission path (unperturbed/pure) and a minimum length of 20 times the waveguide cut-off wavelength in that operational mode.