Article 3

Directive 70/156/EEC is amended as follows:

1. 1..

   Annex I is amended as follows:

   1. (a)

      the following line is added to point 0.5:

      ‘Name and address of authorised representative, if any:’

   2. (b)

      the following point is inserted:

      ‘12.7.

      Table of installation and use of RF transmitters in the vehicle(s), if applicable (see Annex I, 3.1.8.):

      frequency bands (Hz)	max. output power (W)	antenna position at vehicle, specific conditions for installation and/or use

      The applicant for type-approval must also supply, where appropriate:

      • Appendix 1

        A list (with make(s) and type(s) of all electrical and/or electronic components concerned by this Directive (see points 2.1.9 and 2.1.10) and not previously listed.

      • Appendix 2

        Schematics or drawing of the general arrangement of electrical and/or electronic components (concerned by this Directive) and the general wiring harness arrangement.

      • Appendix 3

        Description of vehicle chosen to represent the type

        • Body style:

        • Left or right hand drive:

        • Wheelbase:

      • Appendix 4

        Relevant test report(s) supplied by the manufacturer or approved/recognised laboratories for the purpose of drawing up the type-approval certificate.’

2. 2..

   In Annex III, Section A, the following line is added to point 0.5:

   ‘Name and address of authorised representative, if any:’.