OpenLegislation

Commission Regulation (EU) No 932/2012 of 3 October 2012 implementing Directive 2009/125/EC of the European Parliament and of the Council with regard to ecodesign requirements for household tumble driers (Text with EEA relevance) (revoked)

EU Regulation No 932/2012 · Adopted 3 October 2012 · Extends to United Kingdom

Original text. legislation.gov.uk does not revise this item, so later amendments are not shown here. Changes made to it are listed under each provision when known.

Commission Regulation (EU) No 932/2012

of 3 October 2012

implementing Directive 2009/125/EC of the European Parliament and of the Council with regard to ecodesign requirements for household tumble driers

(Text with EEA relevance) (revoked)

F1. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Annotations to the whole text

Textual amendments

F1

Regulation revoked (10.4.2026) by The Ecodesign for Energy-Related Products and Energy Information (Household Tumble Dryers) Regulations 2026 (S.I. 2026/318), regs. 2(1)(e), 19(a) (with reg. 4)

Contents

  1. 1Subject matter and scope Repealed
  2. 2Definitions Repealed
  3. 3Ecodesign requirements Repealed
  4. 4Conformity assessment Repealed
  5. 5Verification procedure for market surveillance purposes Repealed
  6. 6Benchmarks Repealed
  7. 7Revision Repealed
  8. 8Entry into force and application Repealed
  9. Signature
  10. Annex I: Ecodesign requirements Repealed
  11. Generic ecodesign requirements Repealed
  12. 1.1Division 1.1 Repealed
  13. 1.2The booklet of instructions provided by the manufacturer shall provide: Repealed
  14. 2Specific ecodesign requirements Repealed
  15. Annex II: Method for calculating the energy efficiency index and weighted condensation efficiency Repealed
  16. 1CALCULATION OF THE ENERGY EFFICIENCY INDEX Repealed
  17. 2CALCULATION OF THE WEIGHTED CONDENSATION EFFICIENCY Repealed
  18. Annex IIIProduct compliance verification by market surveillance authorities Repealed
  19. Annex IVBenchmarks Repealed

1Subject matter and scopeF1

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

2DefinitionsF1

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

3Ecodesign requirementsF1

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

4Conformity assessmentF1

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

5Verification procedure for market surveillance purposesF1

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

6BenchmarksF1

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

7RevisionF1

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

8Entry into force and applicationF1

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Signature

F1. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

1.1F1

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

1.2The booklet of instructions provided by the manufacturer shall provide:F1

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

2Specific ecodesign requirementsF1

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

1CALCULATION OF THE ENERGY EFFICIENCY INDEXF1

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

2CALCULATION OF THE WEIGHTED CONDENSATION EFFICIENCYF1

The condensation efficiency of a programme is the ratio between the mass of moisture condensed and collected in the container of a condenser household tumble drier and the mass of moisture removed from the load by the programme, the latter being the difference between the mass of the wet test load before drying and the mass of the test load after drying. For calculating the weighted condensation efficiency, the average condensation efficiency of the standard cotton programme at both full and partial load is considered.

The weighted condensation efficiency (Ct ) of a programme is calculated as a percentage and rounded to the nearest whole percent as:

Ct=3× Cdry+4× Cdry½∕ 7

where:

— Cdry

  • average condensation efficiency of the standard cotton programme at full load,

    • — Cdry½

  • average condensation efficiency of the standard cotton programme at partial load.

    • The average condensation efficiency C is calculated from the condensation efficiencies of test runs and expressed as a percentage:

    C=1n−1∑j=2nWwjWi− Wf×100

    where:

    • n is the number of test runs, comprising at least four valid test runs for the selected programme,

    • j is the test run number,

    • Wwj is the mass of water collected in the condenser reservoir during test run j,

    • Wi is the mass of the wet test load before drying,

    • Wf is the mass of the test load after drying.

    Annex IIIProduct compliance verification by market surveillance authoritiesF1

    . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

    Annex IVBenchmarksF1

    . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .