Annex XI Product compliance verification by market surveillance authorities for process chillersF1

The verification tolerances defined in this Annex relate only to the verification of the measured parameters by F2Great Britain authorities and shall not be used by the manufacturer or importer as an allowed tolerance to establish the values in the technical documentation or in interpreting these values with a view to achieving compliance or to communicate better performance by any means.

F3When verifying the compliance of a product model with the requirements laid down in this Regulation, for the requirements referred to in this Annex the authorities of Great Britain must apply the following procedure—

1. (1)

   The Great Britain authorities shall verify one single unit of the model.

2. (2)

   The model shall be considered to comply with the applicable requirements if:

   1. (a)

      the values given in the technical documentation pursuant to F4paragraph 1(2) of Part 1 of Schedule 1A to the Ecodesign for Energy-Related Products Regulations 2010, and, where applicable, the values used to calculate these values, are not more favourable for the manufacturer or importer than the results of the corresponding measurements carried out pursuant to F5paragraph 1(2)(b)(vii) of Part 1 of Schedule 1A to those Regulations; and

   2. (b)

      the declared values meet any requirements laid down in this Regulation, and any required product information published by the manufacturer or importer does not contain values that are more favourable for the manufacturer or importer than the declared values; and

   3. (c)

      when the Great Britain authorities test the unit of the model, the determined values (the values of the relevant parameters as measured in testing and the values calculated from these measurements) comply with the respective verification tolerances as given in Table 10.

3. (3)

   If the results referred to in point 2(a) or (b) are not achieved, the model shall be considered not to comply with this Regulation.

4. (4)

   If the result referred to in point 2(c) is not achieved, the Great Britain authorities shall select three additional units of the same model for testing.

5. (5)

   The model shall be considered to comply with the applicable requirements if, for these three units, the arithmetical mean of the determined values complies with the respective verification tolerances given in Table 10.

6. (6)

   If the result referred to in point 5 is not achieved, the model shall be considered not to comply with this Regulation.

7. (7)

   F6...

The Great Britain authorities shall use the measurement and calculation methods set out in Annex VIII.

The Great Britain authorities shall only apply the verification tolerances that are set out in Table 10 and shall only use the procedure described in points 1 to F76 for the requirements referred to in this Annex. No other tolerances, such as those set out in F8designated standards or in any other measurement method, shall be applied.