Division 1.1

When applying for EU type-approval for a vehicle, system, component or separate technical unit, the manufacturer shall provide, in accordance with Article 22 of Regulation (EU) No 167/2013, an information folder which shall contain the following:

1. (a)

   a list of contents;

2. (b)

   the information on the type-approval procedure chosen in accordance with Article 20(1) of Regulation (EU) No 167/2013, the template for which is set out in point 2 (information folder sheet);

3. (c)

   the information document as set out in Part B of this Annex;

4. (d)

   all relevant data, drawings, photographs and other information as required in the information document;

5. (e)

   the manufacturer's certificate providing proof of compliance to the type-approval authority on access to vehicle on-board diagnostic (OBD) and to vehicle repair and maintenance information as referred to in Article 53(8) of Regulation (EU) No 167/2013 and set out in Annex II to this Regulation;

6. (f)

   for tractors type-approved with machinery mounted on them and for R- and S-category vehicles, a document setting out the contents of the EC declaration of conformity in accordance with the national provisions implementing Directive 2006/42/EC of the European Parliament and of the Council, not necessarily including the serial number and the signature;

   if requested by the approval authority, the manufacturer shall provide in addition any relevant documentation contained in the technical file of the machinery set out in Annex VII to that Directive, especially:

   • the standards and other technical specifications used, indicating the essential health and safety requirements covered by these standards,

   • any technical report giving the results of the tests carried out either by the manufacturer or by a body chosen by the manufacturer or his authorised representative;

7. (g)

   any additional information requested by the approval authority as part of the approval procedure.

8. (h)

   the manufacturer's declaration on anti-tampering of powertrain and speed-limitation device as referred to in Article 17(2)(b) of Regulation (EU) No 167/2013 and in point 4.3.2 of Annex III to Commission Delegated Regulation (EU) 2015/208^f1 according to the model established in Appendix 24 to this Annex;

9. (i)

   for vehicles equipped with (an) electrical/electronic device(s) which limit its propulsion performance, data and evidence to demonstrate that modification or disconnection of the device or its wiring system will not increase the propulsion performanceF1;

10. (j)

    F2for vehicles of categories T2, T3 and T4.3 equipped with foldable ROPS with an automatic locking system, a certificate of the manufacturer stating that the preliminary test has been done according to the test procedure set out in point 5.5. of Part B3 of Annex IX to Commission Delegated Regulation (EU) No 1322/2014 ^f2 .