OpenLegislation

Division 3.1.3.4.1 F1

United Kingdom

Original text. Later amendments are not shown.

The requirement of point 3.1.3.4 is considered to be fulfilled when the conditions set out in point 3.1.3.4.1.1 are met in the case of a towed vehicle with service brake, or when the conditions set out in point 3.1.3.4.1.2 are met in the case of an unbraked or inertia-braked towed vehicle.

  1. 3.1.3.4.1.1.

    Even with the tractor engine not rotating, the combination at the maximum permissible mass remains stationary on the prescribed gradient when the activation of a single control device by the driver, from his driving seat, has applied the tractor parking braking system and the towed vehicle service braking system or only the tractor parking braking system.

  2. 3.1.3.4.1.2.

    The tractor parking braking system can hold stationary the tractor connected to an unbraked or inertia-braked towed vehicle having a mass equal to the highest ‘combination mass P M+R ’ mentioned in the test report. This mass shall be determined as follows:

    1. (a)

      in the case of unbraked towed vehicle: P M+R = combination mass (mass P M + declared unbraked towed vehicle mass P R ) according to point 3.1.1.2;

    2. (b)

      in the case of an inertia braked towed vehicle: P M+R = combination mass (mass P M + declared inertia-braked towed vehicle mass as specified by the manufacturer).

      P M = mass of the tractor (if applicable, including any ballast or supporting load or both of them).

Annotations

Textual amendments

F1

Substituted by Commission Delegated Regulation (EU) 2016/1788 of 14 July 2016 amending Regulation (EU) No 167/2013 of the European Parliament and of the Council as regards the list of requirements for vehicle EU type-approval, and amending and correcting Commission Delegated Regulations (EU) No 1322/2014, (EU) 2015/96, (EU) 2015/68 and (EU) 2015/208 with regard to vehicle construction and general requirements, to environmental and propulsion unit performance requirements, to vehicle braking requirements and to vehicle functional safety requirements (Text with EEA relevance).