Division 1
United Kingdom
For the purposes of compliance and verification of compliance with the requirements of this Regulation, measurements and calculations shall be made using F1designated standards, or other reliable, accurate and reproducible method, which takes into account the generally recognised state-of-the-art methods. They shall fulfil the conditions and technical parameters set out in points 2 to 8.
Annotations
Textual amendments
- F1
Words in Annex 3 para. 1 substituted (31.12.2020) by The Ecodesign for Energy-Related Products and Energy Information (Amendment) (EU Exit) Regulations 2019 (S.I. 2019/539), reg. 1(3), Sch. 2 para. 28(9); 2020 c. 1, Sch. 5 para. 1(1)
Notes on Annex III
Footnotes
- f1
The wet bulb temperature condition is not required when testing units which do not evaporate condensate.
- f2
For units designed for heating and cooling mode, the flow rate obtained during the test at standard rating conditions in cooling mode is used.
- f3
Outlet temperatures dependent on water flow rate as determined at standard rating conditions (100 % part load ratio when cooling, 88 % when heating)
- f4
With the water flow rate determined during ‘A’ test for units with a fixed water flow rate or with a variable flow rate.
- f5
With the water flow rate determined during ‘A’ test for units with a fixed water flow rate or with a variable flow rate.