OpenLegislation

Division 4.2.2 Utility factor-weighted charge-depleting fuel consumption for OVC-HEVs

Original text. Later amendments are not shown.

The utility factor-weighted charge-depleting fuel consumption FCCD shall be calculated using the following equation:

FCCD=∑kj= 1UFj× FCCD,j∑kj= 1UFj

where:

FCCD

  • is the utility factor weighted charge-depleting fuel consumption, l/100 km;

    • FCCD,j

  • is the fuel consumption for phase j of the charge-depleting Type 1 test, determined according to paragraph 6. of Sub-Annex 7, l/100 km;

    • UFj

  • is the utility factor of phase j according to Appendix 5 of this Sub-Annex;

    • j

  • is the index number of the phase considered;

    • k

  • is the number of phases driven up to the end of the transition cycle according to paragraph 3.2.4.4 of this Sub-Annex.

    • F1In the case that the interpolation method is applied, k shall be the number of phases driven up to the end of the transition cycle of vehicle L nveh_L.

    If the transition cycle number driven by vehicle H, nvehH, and, if applicable, by an individual vehicle within the vehicle interpolation family, nvehind, is lower than the transition cycle number driven by vehicle L nveh_L the confirmation cycle of vehicle H and, if applicable, an individual vehicle shall be included in the calculation. The fuel consumption of each phase of the confirmation cycle shall be calculated in accordance with paragraph 6. of Sub-Annex 7 with the criteria emission over the complete confirmation cycle and the applicable CO2 phase value which shall be corrected to an electric energy consumption of zero, ECDC,CD,j = 0, by using the CO2 mass correction coefficient (KCO2) in accordance with Appendix 2 to this Sub-Annex.

    Annotations

    Textual amendments

    F1

    Substituted by Commission Regulation (EU) 2018/1832 of 5 November 2018 amending Directive 2007/46/EC of the European Parliament and of the Council, Commission Regulation (EC) No 692/2008 and Commission Regulation (EU) 2017/1151 for the purpose of improving the emission type approval tests and procedures for light passenger and commercial vehicles, including those for in-service conformity and real-driving emissions and introducing devices for monitoring the consumption of fuel and electric energy (Text with EEA relevance).