OpenLegislation

Paragraph 5.3.2.2 SPECIFICATION OF CONFORMITY OF PRODUCTION ASSESSMENTS

Changes not yet applied. Later legislation changes this provision in ways not yet written into the text below:

if the engine taken from the series does not satisfy the requirements of section 5.3.2.1 the manufacturer may ask for measurements to be performed on a sample of engines of the same specification taken from the series and including the engine originally taken. The manufacturer shall determine the size n of the sample in agreement with the technical service. Engines other than the engine originally taken shall be subjected to a test. The arithmetical mean (

  • x¯

    ) of the results obtained with the sample shall then be determined for each pollutant. The production of the series shall then be deemed to confirm if the following condition is met:

  • x¯+K*St≤L

    f1

    where:

    L is the limit value laid down in section 4.2.1/4.2.3 for each pollutant considered,

    k is a statistical factor depending on n and given in the following table:

    n2345678910
    k0.9730.6130.4890.4210.3760.3420.3170.2960.279
    n111213141516171819
    0.2650.2530.2420.2330.2240.2160.2100.2030.198
ifn ≥20,k= 0.860n

Annotations

Footnotes

f1
St2=Σ(x-x_)2n-1

where x is any one of the individual results obtained with the sample n.