OpenLegislation

Regulation 10B Provisional type-approvalsF1

(1)

Where the approval authority is satisfied on application made to it by the manufacturer of a qualifying relevant product—

(a)

that the manufacturer holds in respect of that qualifying relevant product a relevant European approval; and

(b)

that adequate arrangements have been made to secure that other products conform with that qualifying relevant product in the relevant aspects of design, construction, equipment and marking will so conform in all respects or with such variations as may be permitted,

the approval authority may, where an application has been received before the expiry of the relevant period, grant type-approval for the qualifying relevant product and issue the corresponding type-approval certificate.

(2)

The approval authority may approve an application under paragraph (1) where the application was made before 11 p.m. on 31st December 2022.

(3)

If the type-approval certificate is issued following approval under paragraph (1), the certificate is to remain in force—

(a)

for a period of two years beginning with the day of issue; or

(b)

(if earlier) until such time as the manufacturer is notified by the approval authority in writing that the authority is no longer satisfied that the products purporting to conform with the qualifying relevant product do so conform.

(4)

Where the approval authority gives notice to the manufacturer under paragraph (3)(b), that notice must set out the reasons for the authority’s opinion.

(5)

For the purposes of paragraph (1)—

(a)

“relevant European approval” means a valid type-approval issued—

(i)

before IP completion day in a member State other than in the United Kingdom in accordance with the NRMM Regulation; or

(ii)

on or after IP completion day in a member State in accordance with the EU NRMM Regulation,

including any such approval which is revised or extended;

(b)

the “relevant period” means the period beginning with the day on which this regulation comes into force, and ending with 31st December 2027;

  • “qualifying relevant product”, means a relevant product which is intended to be placed on the market, or which is to be entered into service, in Great Britain.

(6)

This regulation applies notwithstanding any other provision in these Regulations or the NRMM Regulation.

Annotations

Textual amendments

F1

Reg. 10B inserted (31.12.2022 at 11.00 p.m.) by The Road Vehicles and Non-Road Mobile Machinery (Type-Approval) (Amendment and Transitional Provisions) (EU Exit) Regulations 2022 (S.I. 2022/1273), regs. 1(2), 10(4)