OpenLegislation

The Pipe-lines (Metrication) Regulations 1992

S.I. 1992/449 · Made 28 February 1992

Original text. legislation.gov.uk does not revise statutory instruments, so later amendments are not shown here. Changes made to it are listed under each provision when known.

PIPE-LINES

Made 28th February 1992

Laid before Parliament 6th March 1992

Coming into force 1st April 1992

The Secretary of State, being a Minister designatedf1 for the purposes of section 2(2) of the European Communities Act 1972f2 in relation to units of measurement to be used for economic, health, safety or administrative purposes, in exercise of the powers conferred by section 2(2) and (4) of the said Act of 1972, and of all other enabling powers, hereby makes the following Regulations:

Annotations to the whole text

Footnotes

f1

S.I. 1976/897.

f2

1972 c. 68.

Contents

  1. 1Citation and commencement
  2. 2Amendment of Pipe-lines Act 1962
  3. 3Amendment of Pipe-lines (Limits of Deviation) Regulations 1962
  4. Signature
  5. Explanatory note

1Citation and commencement

These Regulations may be cited as the Pipe-lines (Metrication) Regulations 1992 and shall come into force on 1st April 1992.

2Amendment of Pipe-lines Act 1962

(1)

In this regulation any reference to a section or a Schedule followed by a number is a reference to the section or Schedule bearing that number in the Pipe-lines Act 1962f1.

(2)

With effect from 1st January 1995—

(a)

in the following provisions (which specify the minimum scale of a map on which the route of a pipe-line is delineated)—

(i)

sections 2(2)(b) and 8(1)(b);

(ii)

paragraphs 1(b) and 7 of Schedule 1; and

(iii)

paragraphs 1(b) and 7(1) of Schedule 2, “six inches to the mile” there shall be substituted “1 in 10,560”;

(b)

in the following provisions (which specify the maximum length of a pipe-line for certain purposes)—

(i)

section 3(1);

(ii)

section 7(1); and

(iii)

the definition of “cross-country pipe-line” in section 66(1), “ten miles”, in each place where they occur, there shall be substituted “16.093 kilometres”; and

(c)

in section 27(1) and (6) (which specify the minimum distance between a pipe-line and a building or structure) and 31(1) (which specifies the minimum distance between a pipe-line and any deposit of earth or other materials) for the words “ten feet” there shall be substituted “3 metres”.

3Amendment of Pipe-lines (Limits of Deviation) Regulations 1962

With effect from 1st January 1995, in regulation 3 of the Pipe-lines (Limits of Deviation) Regulations 1962f1 (which limits the extent to which the route of a local pipe-line can deviate from the route delineated on a map submitted to the Secretary of State), for the words “one hundred feet” there shall be substituted “30 metres”.

Signature

John Wakeham

Secretary of State for Energy

28th February 1992

Explanatory note

(This note is not part of the Regulations)

These Regulations implement, for the purposes of the Pipe-lines Act 1962 and the Pipe-lines (Limits of Deviation) Regulations 1962, Council Directive No. 80/181/EEC (O.J. 1980, L39, 15.2.80, p.40) as amended by Council Directive No. 89/617/EEC (O.J. 1989, No. L357, 7.12.89, p.28), which establish the legal units of measurement to be used throughout the Community.

The following changes are made—

(a)

Pipe-lines Act 1962

(i)

scale of maps — references to “six inches to the mile” are replaced by references to “1 in 10,560”;

(ii)

length of pipe-lines — references to “ten miles” in sections 3(1), 7(1) and 66(1) are replaced by references to “16.093 kilometres”; and

(iii)

in sections 27(1) and (6) and 31(1) (buildings etc. imperilling pipe-lines) — references to “ten feet” are replaced by references to “3 metres”.

(b)

In the Pipe-lines (Limits of Deviation) Regulations 1962 the reference to “one hundred feet” is replaced by a reference to “30 metres”.