Regulation 28 Amendment of regulation 56F1I1

Regulation 56 (cones, delineators and cylinders) is amended as follows.

For paragraph (2), substitute—

“(2)

A cone shall consist of a conically shaped device—

(a)

the base of which—

(i)

is of any single colour; and

(ii)

is a polygon, having not more than eight sides, which would be contained wholly within a circle with a diameter of three quarters of the height of the cone; and

(b)

which, subject to paragraph (15), conforms to British Standard BS EN 13422:2004+A1:2009 or to a corresponding EEA Standard.”.

In paragraph (5), for “British Standard Specification BS873: Part 8: 1985” substitute “British Standard BS EN 13422:2004+A1:2009”.

In paragraph (7), for sub-paragraph (b), substitute—

“(b)

which conforms to British Standard BS 8442:2006 or to a corresponding EEA Standard;”.

In paragraph (10), for “British Standard Specification BS 873: Part 8: 1985” substitute “British Standard BS EN 13422:2004+A1:2009”.

In paragraph (11), for “made of rubber or flexible plastic material” substitute “which, subject to paragraph (15), conforms to British Standard BS EN 13422:2004+A1:2009 or to a corresponding EEA Standard”.

In paragraph (14), for “British Standard Specification BS873: Part 8: 1985” substitute “British Standard BS EN 13422:2004+A1:2009”.

After paragraph (14), insert—

“(15)

In relation to each aspect of performance specified in column (2) of an item in the Table, a cone or cylinder shall comply with—

(a)

the requirement or test specification of British Standard BS EN 13422:2004+A1:2009 specified in column (3) of the item; or

(b)

an equivalent requirement or test specification specified in a corresponding EEA Standard.

Table

(1) Item	(2) Aspect of performance	(3) Requirement or test specification and class
1.	Daylight chromaticity co-ordinates and luminance factors	Retroreflective material: Class LB in Table 2
		Non-retroreflective exterior surfaces: Table 3.A
		Non-retroreflective interior surfaces: Table 3.B
2.	Coefficient of retroreflection	Dry conditions: Class R1B or R2B in Table 4.B
		Wet conditions: Class WT 1 in Table 6
3.	Height and minimum weight (cones)	Class W3 in Table 1

”