Paragraph 1

The technical documentation referred to in regulation 12(1)(e) must include the following—

(a)

the name and address of the supplier;

(b)

the supplier’s model identifier;

(c)

the model identifier of all equivalent models already placed on the market;

(d)

identification and signature of the person empowered to bind the supplier;

(e)

the declared values for the following technical parameters—

(i)

useful luminous flux (Φ_use) in lm;

(ii)

colour rendering index (CRI);

(iii)

on-mode power (P_on) in W;

(iv)

beam angle in degrees for directional light sources (DLS);

(v)

peak luminous intensity in cd for directional light sources (DLS);

(vi)

correlated colour temperature (CCT) in K;

(vii)

standby power (P_sb) in W, including when it is zero;

(viii)

networked standby power (P_net) in W for connected light sources (CLS);

(ix)

R9 colour rendering index value for LED and OLED light sources;

(x)

survival factor for LED and OLED light sources;

(xi)

lumen maintenance factor for LED and OLED light sources;

(xii)

indicative lifetime L70B50 for LED and OLED light sources;

(xiii)

displacement factor (cos φ1) for LED and OLED mains light sources;

(xiv)

colour consistency in MacAdam ellipse steps for LED and OLED light sources;

(xv)

luminance-HLLS in cd/mm² (only for HLLS)

(xvi)

flicker metric (PstLM) for LED and OLED light sources;

(xvii)

stroboscopic effect metric (SVM) for LED and OLED light sources;

(xviii)

excitation purity, only for CTLS, for the colours and dominant wavelength within the given range in the following table—

Colour	Dominant wavelength range
Blue	440 nm - 490 nm
Green	520 nm - 570 nm
Red	610 nm - 670 nm

(f)

the calculations performed with the parameters, including the determination of the energy efficiency class;

(g)

references to the designated standards applied or other standards used;

(h)

testing conditions if not described fully in sub-paragraph (g);

(i)

the reference control settings, and instructions on how they can be implemented, where applicable;

(j)

instructions on how to remove lighting control parts and/or non-lighting parts, if any, or how to switch them off or minimise their power consumption during light source testing;

(k)

specific precautions that must be taken when the model is assembled, installed, maintained or tested;

(l)

where a claim of the kind referred to in paragraph 2(1) or (3) of Schedule 8 is made, the data to support such a claim.