Paragraph 6 Commission Regulation (EC) No 640/2009I1

Commission Regulation (EC) No 640/2009 of 22 July 2009 implementing Directive 2005/32/EC of the European Parliament and of the Council with regard to ecodesign requirements for electric motors is amended as follows.

In Article 2 (definitions), at the beginning, for the words from “In addition” to “shall apply:”, substitute—

“The definitions set out in the Ecodesign for Energy-Related Products Regulations 2010 apply; and for any term that is not defined in those Regulations, the definitions set out in Directive 2009/125/EC of the European Parliament and of the Council of 21 October 2009 establishing a framework for the setting of ecodesign requirements for energy-related products, as it had effect immediately before F1IP completion day, apply. The following definitions also apply—”.

For Article 4 (conformity assessment), substitute—

“For the purposes of regulation 4(2)(a) of the Ecodesign for Energy-Related Products Regulations 2010, the procedure for assessing whether an energy-related product complies with this implementing measure is the internal design control system set out in Part 1 of Schedule 1A to the Ecodesign for Energy-Related Products Regulations 2010 or the management system for assessing conformity set out in Part 2 of Schedule 1A to those Regulations.”.

For Article 5 (verification procedure for market surveillance purposes), substitute—

“When performing market surveillance checks to assess compliance with the requirements set out in this Regulation, the authorities of F2Great Britain must apply the verification procedure described in Annex 3.”.

Omit Article 7 (revision).

At the end of Article 8 (entry into force), omit “This Regulation shall be binding in its entirety and directly applicable in all Member States.”.

Annex 3 (product compliance verification by market surveillance authorities) is amended as follows—