Division BAT-associated emission levels
United Kingdom
See Table 2.
Table 2
BAT-associated emission levels for NOx from the flue-gases of kiln firing and/or preheating/precalcining processes in the cement industry
| The upper level of the BAT-AEL range is 500 mg/Nm3, if the initial NOx level after primary techniques is > 1 000 mg/Nm3. | ||
| Existing kiln system design, fuel mix properties including waste and raw material burnability (e.g. special cement or white cement clinker) can influence the ability to be within the range. Levels below 350 mg/Nm3 are achieved at kilns with favourable conditions when using SNCR. In 2008, the lower value of 200 mg/Nm3 has been reported as a monthly average for three plants (easy burning mix used) using SNCR. | ||
| Depending on initial levels and NH3 slip. | ||
| Kiln type | Unit | BAT-AEL(daily average value) |
|---|---|---|
| Preheater kilns | mg/Nm3 | < 200 – 450f1 f2 |
| Lepol and long rotary kilns | mg/Nm3 | 400 – 800f3 |
Annotations
Footnotes
- f1
-
The upper level of the BAT-AEL range is 500 mg/Nm3, if the initial NOx level after primary techniques is > 1 000 mg/Nm3.
- f2
-
Existing kiln system design, fuel mix properties including waste and raw material burnability (e.g. special cement or white cement clinker) can influence the ability to be within the range. Levels below 350 mg/Nm3 are achieved at kilns with favourable conditions when using SNCR. In 2008, the lower value of 200 mg/Nm3 has been reported as a monthly average for three plants (easy burning mix used) using SNCR.
- f3
-
Depending on initial levels and NH3 slip.
Notes on Division 19
Footnotes
- f1
-
A description of the techniques is provided in Section 1.5.2.