OpenLegislation

Division BAT-associated emission levels

United Kingdom

Original text. Later amendments are not shown.

See Table 16. These BAT-AELs also apply to mechanical pulp mills. The reference waste water flow for integrated mechanical, CTM and CTMP pulp mills are set out in BAT 5.

Table 16

BAT-associated emission levels for the direct waste water discharge to receiving waters from the integrated production of paper and board from mechanical pulps produced on site

In the case of highly bleached mechanical pulp (70-100 % of fibre in final paper), emission levels of up to 8 kg/t may occur.

When biodegradable or eliminable chelating agents cannot be used due to pulp quality requirements (e.g. high brightness), the emissions of total nitrogen might be higher than this BAT-AEL and should be assessed on a case-by-case basis.

ParameterYearly averagekg/t
Chemical oxygen demand (COD)0,9 – 4,5f1
Total suspended solids (TSS)0,06 – 0,45
Total nitrogen0,03 – 0,1f2
Total phosphorus0,001 – 0,01

Table 17

BAT-associated emission levels for the direct waste water discharge to receiving waters from a CTMP or CMP pulp mill

When biodegradable or eliminable chelating agents cannot be used due to pulp quality requirements (e.g. high brightness), the emissions of total nitrogen might be higher than this BAT- AEL and should be assessed on a case-by-case basis.

ParameterYearly averagekg/ADt
Chemical oxygen demand (COD)12 – 20
Total suspended solids (TSS)0,5 – 0,9
Total nitrogen0,15 – 0,18f3
Total phosphorus0,001 – 0,01

The BOD concentration in the treated effluents is expected to be low (around 25 mg/l as a 24-hour composite sample).

Annotations

Footnotes

f1

In the case of highly bleached mechanical pulp (70-100 % of fibre in final paper), emission levels of up to 8 kg/t may occur.

f2

When biodegradable or eliminable chelating agents cannot be used due to pulp quality requirements (e.g. high brightness), the emissions of total nitrogen might be higher than this BAT-AEL and should be assessed on a case-by-case basis.

f3

When biodegradable or eliminable chelating agents cannot be used due to pulp quality requirements (e.g. high brightness), the emissions of total nitrogen might be higher than this BAT- AEL and should be assessed on a case-by-case basis.