Division 4.1.5.1 Test runF1
United Kingdom
The following test procedure applies for each test run:
- (1)
The passenger car is driven in a straight line up to 85 ± 2 km/h.
- (2)
Once the passenger car has reached 85 ± 2 km/h, the brakes are always activated at the same place on the test track referred to as ‘ braking starting point ’ , with a longitudinal tolerance of 5 m and a transverse tolerance of 0,5 m.
- (3)
The brakes are activated either automatically or manually.
- (i)
The automatic activation of the brakes is performed by means of a detection system made of two parts, one indexed to the test track and one on board the passenger car.
- (ii)
The manual activation of the brakes depends on the type of transmission as follows. In both cases, a minimum of 600 N pedal efforts is required.
For manual transmission, the driver should release the clutch and depress the brake pedal sharply, holding it down as long as necessary to perform the measurement.
For automatic transmission, the driver should select neutral gear and then depress the brake pedal sharply, holding it down as long as necessary to perform the measurement.
- (i)
- (4)
The average deceleration is calculated between 80 km/h and 20 km/h.
If any of the specifications listed above (including speed tolerance, longitudinal and transverse tolerance for the braking starting point, and braking time) are not met when a test run is made, the measurement is discarded and a new test run is made.